19
Decorative brick panels must be installed before the logs.
See installation instructions supplied with the panel kit.
LOG PLACEMENT
PHAZERTM logs, exclusive to Napoleon Fireplaces, provide a unique and realistic glowing effect that is different in every installation. The madison logs are fuel specific. Do not
interchange. Refer to the replacement parts list.
FIGURE 40a-f
1
4
4.Place log #4, with the charred branch pointed inward. Locate the pins into the holes in log#1 and log#2, this will hold the rear log in position.
1.Place the rear log #1 onto the locating studs along the back edge of the PHAZERAMIC™ burner.
2
2.Position log #2 onto the locators on the PHAZERAMIC™ burner.
3
3.Position the slot on the bottom of log #3 onto the bracket shown with the charred face of the log to the front.
Note |
|
For propane, remove the | BRACKET |
screw from the #3 log support | |
bracket. Move the bracket to |
|
the right most location, then |
|
install the log. |
|
5
5.Place the end of log #5 on the right end of log #1. The fork in the log should straddle the knot on top of log #2.
GLOWING EMBERS
Glowing embers are NOT recommended. The burner has been designed to achieve maximum glow without embers.
BAFFLE INSTALLATION
Your fireplace has been supplied with the decorative brick panels installed, however, it is necessary to install the fibre baffle, on top of the side and rear panels.
CHARCOAL EMBERS
Charcoal provided could be randomly placed on the fibre hearth on both sides of the burner, and across the front, es- pecially at the hearth joint.
Log colours may vary. During the initial use of the fire- place, the colours will become more uniform as colour pigments burn in during the heat activated curing pro- cess.
Positioning the logs improperly will cause flame impinge- ment and carboning.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZERTM logs glow when exposed to direct flame. Use only certified PHAZERTM logs available from your Napoleon dealer.