Vermont Casting s Radiance Manual: Homeowners Installation and Operating Guide

Page 1

INSTALLER / CONSUMER SAFETY INFORMATION

Please read this manual before installing and using appliance.

WARNING: If the information in this manual is not followed ex- actly, a fire or explosion may result causing property damage, personal injury or loss of life.

FOR YOUR SAFETY

Installation and service must be per- formed by a qualified installer, service agency or the gas suppler.

WHAT TO DO IF YOU SMELL GAS

Shut off the gas supply.

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

If you cannot reach your gas supplier, call the fire department.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WARNING: Improper installa- tion, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual for correct installa- tion and operational procedures. For assistance or additional infor- mation consult a qualified installer, service agency, or the gas supplier.

This is an unvented gas-fired heater. It uses air (Oxygen) from the room which it is installed. Provisions for adequate combustion and ventilation air must be provided.

Installation and service must be performed by a qualified in- staller, service agency or the gas supplier.

Radiance

Vent Free Gas Heater

Model RUVS40

0456

Homeowner’s Installation

and Operating Manual

Tested and listed to

ANSI Z21.11.2b-1998, Unvented Heaters

INSTALLER: DO NOT DISCARD THIS MANUAL -

LEAVE FOR HOMEOWNER

3000-0456c/1000

Image 1
Contents Radiance Table of Contents Radiance Unvented Gas Heater RUVS40 SpecificationsFuel Type Carbon Monoxide Poisoning MAY Lead to Death Safety InformationQuick Installation Vent Free FeaturesGeneral Information Optional Fan Kit #2767 /FK26Fresh Air Requirements for Combustion and Ventilation Installation RequirementsProvide For Adequate Ventilation Unusually Tight ConstructionVent options to provide additional air Hearth Requirements Minimum Clearances to Combustible MaterialsFreestanding Stove Alcove ClearancesHardware Bag Contents AssemblyUnpacking the Radiance Remove the Front, Screen and LogsKit Contents used with the RUVS40 Install Optional Fan, #2767/FK26Install the Control Switch. Fig AA DResecure the Rear Shroud panels Attach the fan assembly to the fan bracketConnect the Gas Line Thermostat Connection optionalRemove the valve cover plate Install the LogsReplace the front panel Complete the InstallationYour First Fire OperationPilot and Burner Inspection For Your Safety Read Before Lighting Trouble No spark at Pilot when Ignitor is operatedCondition Possible Cause Solution TroubleshootingOdor During Operation Cleaning Procedure Firebox Cleaning and InspectionGlass Replacement Care of Cast IronCatalytic Combustor Clean the combustor moduleRemove the combustor module Replace the combustor moduleRadiance Vent Free Gas Heater RUVS40 #10-24 X 1/4 Phil. Pn Hd Screw RUVS40Limited One Year Warranty Limited Three Year WarrantyHow To Obtain Service Exclusions and LimitationsVermont Castings Majestic Products Company