Resecure the Rear Shroud panels | Vermont Casting RUVS40 instruction

5.Resecure the Rear Shroud panels.

•Reinstall and tighten the two sheet metal screws (D, Fig. 10) that secure the inner and outer shrouds together.

•Secure the upper corner of the shroud and switch box to the side of the stove using a 1/4 -20 x 1/2” round head phillips screw, previously removed. (B, Fig.10)

Finally, replace the lower screw.

6.Attach the fan assembly to the bracket removed earlier. Remove the sheet metal screws that secure the finger guards at each end of the fan housing. Use these screws to attach the fan to the bracket. (Fig. 12)

•Position the fan assembly so that the ducts slide between the inner and outer shroud. The inner shroud should engage with the two slots in the ends of the bracket so that bracket and shroud are interlocked. (Fig.14) Secure the bracket with the four sheet metal screws previously removed.

Fan Bracket

ST193	Finger Guard

Fig. 12 Attach the fan assembly to the fan bracket.

Outer	Slot
Shroud
	{Inner Shroud}
	Slot
	ST194

Fig. 13 Position the fan to engage the inner shroud with the fan bracket slots and secure with sheet metal screws.

Vermont Castings Radiance

7.Install snapstat. (Fig. 13) Looking through the stove front, locate the snapstat mounting screws on the side of the left air duct under the top plate. Remove the front screw (A), but only loosen the rear screw. Slip the snapstat under the rear screw, replace the front screw, and tighten both.

•Detach the extension wire from the retainer clip at the rear. Connect the female flag connectors (B) of the snapstat extension to the snapstat module. Confirm that the wires are running to the back and away from the top of the stove.

8.Plug the power cord into a standard grounded 110- volt household outlet. If the fan control knob is not turned

to the OFF position, the fan will turn on when the tem- perature at the snapstat reaches approximately 109°F.

Left Air Duct	Snapstat
Left Air Duct
	B
	A
	ST195

Fig. 14 Install the snapstat and connect the extension wire terminals. View is with top removed, however, access is available through the grate opening in the top plate.

MOTORDisconnect power before servicing.

BLK	BLK	BLK SNAPSTAT
		BLK SNAPSTAT
WHT	BLK	WHT
WHT	GRN	RHEOSTAT
		ON/OFF
	POWER

ST196

Fig. 15 2767 / FK26 Fan Wiring Diagram

WARNING

The optional fan kit is equipped with a three- prong (grounding) plug for your protection against shock hazard and should be plugged directly into

aproperly grounded three-prong outlet. Do not cut or remove the grounding prong from this

plug.