Vermont Castings Radiance
4.Loosely sprinkle the lava rocks (#6) directly on top of the burner, between the front and middle logs. Do not place any ember or lava material behind the middle logs. (Fig. 22)
| 7 |
| 6 |
| ST144 |
Fig. 22 | Install the lava rocks and top log. |
5.Engage the sockets in the underside of the top log (#7) with the pegs on the rear log and the left middle log as shown in Figure 22. Ensure that the top log is positioned properly, relative to the right middle log, as shown in Figure 23.
3Z\x” 
(88.9mm)
ST145a
Fig. 23 Confirm that the top log is properly located by measuring 3Z\x inches from the left inside wall of the firebox to the end of the left branch of the top log.
Complete the Installation
1.Replace the screen frame or glass frame assem- bly by resting the bottom edge of the frame on support brackets below the front opening of the firebox. Swing the top edge of the assembly toward the firebox, and center it. Fasten it by closing the latches over the top left and right edges of the frame.
2.Replace the stove front by grasping it by the left and right edges. Lift it so that tabs on the back side of the top corners engage notches at the top forward corners of the stove sides. Then gently swing the bottom of the front panel to a vertical position, and lower it till prongs on its bottom left and right corners engage with notches cast into the tops of the forward legs. (Fig. 24) Test that the front is installed securely by grasping two of panel’s vertical bars, and pulling the panel toward yourself. When the panel is in place properly you should not be able to pull the bottom of the front toward yourself without also lifting it.
3.Attach the wooden handle to the control door using the
4.Set the screen and the
This completes the installation and assembly of the Radiance RUVS40.
ST135a
Fig. 24 Replace the front panel.
ST197
Fig. 25 Attach the handle to the control door.
14