Vermont Casting RUVS40 manual Install the Logs, Remove the valve cover plate

ADJPILOT

H

I

ST172

Fig. 17 Remove the valve cover plate.

ADJPILOT

ON

O H

I

OFF

ST173

Fig. 18 Flexible gas line connection.

Pilot	On/Off
	Control
Adjustment	Knob
Screw			Regulator
PILOT ADJ
TPTH		ON	L	O H
				I
TP	PILOT
	OFF
TH
Pressure Tap		Piezo
		Ignitor		HV100

Fig. 19 The gas control valve includes a captured screw- type pressure test point. A pressure test point upstream from the control valve is not required.

Vermont Castings Radiance

Install the Logs

Install the logs in sequence as shown below. The log set includes six sections: the rear log, left and right middle logs, left and right ember logs, and an upper log. There is also a bag of lava rocks which simulate charcoal and embers.

1.Install the rear log (#1, Fig. 20) by engaging holes on its bottom surface with pins on the sheet-metal shelf at the back of the firebox.

2.Install the left and right middle logs (#2 and #3, Fig. 20) by engaging holes on their bottom surfaces with pins on the burner brackets.

2	1	3
	Brackets
		ST142
Fig. 20	Install rear and middle logs.

3.Push the burner assembly fully to the rear. There should be a gap of about 13/16” between the front of the burner and the inside front wall of the firebox. Place the two front ember log sections (#4 and 5, Fig. 21) in the slot at the front of the firebox, just in front of the burner.

	5
	4
	ST143
Fig. 21	Install the front ember logs.
	13