Product Identification, Unpacking | Vanguard Heating VSGF-28NTE

PRODUCT

IDENTIFICATION

Middle Log	Rear Burner
	Rear
Front	Log
Front
Log

Front Burner

Figure 1 - Log Base Assembly, Split Oak Set

Top Louver	Top Outer
Assembly	Casing
Fireplace
Hood
Firebox
Support

Screen

Assembly

Bottom Louver	Blower
Assembly	Assembly

Figure 2 - Fireplace

UNPACKING

CAUTION: Do not remove the data plates attached to the heater base assembly. The data plates contain important warranty and safety information.

1.With utility knife, cut the carton all the way around above the staples on the bottom tray. Lift the carton off the heater. Remove packing. Note: The hood is located in the packing on the right hand side of the heater front. Lift the heater off the bottom tray.

2.Locate two screws above top corners of the ﬁreplace screen. Remove and discard these screws. Lift ﬁreplace screen up and pull out to remove.

3.Remove protective packaging applied to logs, log base assembly, and ﬁreplace.

4.Remove ﬁreplace hood from carton insert.

5.Check all items for any shipping damage. If damaged, promptly inform dealer where you bought ﬁreplace.

PRODUCT FEATURES

OPERATION

This vent-free ﬁreplace is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by both realistic ﬂames and glowing embers. When used without the blower, the ﬁreplace requires no electricity making it ideal for emergency backup heat.

SAFETY DEVICE

This ﬁreplace has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/ pilot is a required feature for vent-free room heat- ers. The ODS/pilot system shuts off the ﬁreplace if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This ﬁreplace has a piezo ignitor. This system requires no matches, batteries, or other sources to light ﬁreplace.

BLOWER ASSEMBLY

This ﬁreplace has a blower assembly. The blower operates thermostatically and has a variable speed control. The blower circulates heated air from the ﬁreplace into the room. Use of blower is optional.

THERMOSTAT CONTROL

This ﬁreplace has a thermostat sensing bulb and a control valve. The thermostat controls the heat output and ﬂame height. This maintains a consis- tent room temperature. Even the lowest setting provides realistic ﬂames and glowing embers from two burners. Selecting higher comfort settings al- lows ﬁreplace to run longer, producing greater heat output. At lower comfort settings, the ﬁreplace will run less. This results in increased heating comfort. This can also result in lower gas bills.

113135-01C