Vanguard Heating VSGF-28NTE, VSGF-28PTE Check GAS Type, Electrical Hookup, Installing Hood

Set Screws

INSTALLATION

Continued

IMPORTANT: Vent-free heaters add moisture to the air. Although this is beneficial, installing fire- place in rooms without enough ventilation air may cause mildew to form from too much moisture. See Air for Combustion and Ventilation, page 6.

IMPORTANT: Make sure the fireplace is level. If fireplace is not level, log set will not work properly.

CHECK GAS TYPE

Use the correct gas type (natural or propane/LP). If your gas supply is not correct, do not install fireplace. Call dealer where you bought fireplace for proper type fireplace.

WARNING: This appliance is equipped for (natural or pro- pane/LP) gas. Field conversion is not permitted.

ELECTRICAL HOOKUP

This fireplace has a blower assembly with an electrical cord. The electrical cord is five feet in length. You must locate fireplace within reach of a 120-volt grounded electrical outlet. If not, you must install an electrical outlet within reach of fireplace power cord. The GA3555 outlet acces- sory may be used for built-in installation when a blower is installed.

INSTALLING HOOD

Install hood to rail already installed in fireplace as shown in Figure 5. Use 3 Phillips screws provided.

Rail

Hood

Screw

ASSEMBLING AND ATTACHING OPTIONAL PERIMETER TRIM (Included with Mantel Accessory)

IMPORTANT: If you are recessing the firebox in a wall, do not attach trim at this time. See page 10 for built-in fireplace installation.

Note: The instructions below show assembling and attaching trim to fireplace.

1.Remove packaging from three pieces of trim.

2.Locate four screws, two adjusting plates with set screws, and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 6.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 6).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 6).

6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screwdriver.

7.Repeat steps 1 through 6 for other side.

8.Tighten trim hanging screws (#10 x 6.25 shoulder) into holes in cabinets. Place the assembled trim onto fireplace cabinet. Align hanging notches on trim with hanging screws on side of fireplace (see Figure 7). Push trim firmly into place, sliding hanging notches over

hanging screws.

Side Trim	Adjusting	Top
	Plate
		Trim
Slot
	Shim
	Mitered Edge	Slot
Figure 6 - Assembling Perimeter Trim
	Trim Hanging
	Screws

Figure 5 - Installing Hood

Assembled
Trim	Hanging Notches
	on Trim
Figure 7 - Attaching Perimeter Trim to
	Fireplace

113135-01C www.desatech.com 9