User Manual version 2007
B: DiskOnChip® Installation
The APOLLO 120/150 III is equipped with an internal flash disk which can emulate a floppy disk drive by adapting DiskOnChip® memory chips from 2MB to 144MB capacity, and the flash disk is fully compatible with floppy disk format of
To install a DiskOnChip® memory to the provided socket, follow the instructions below;
1.Make sure the computer is turned off
2.Insert the DiskOnChip® memory device into the onboard socket. Make sure that pin 1 of the DiskOnChip® is aligned with the pin 1 of the socket.
3.Power up the computer
4.During the power up, the DiskOnChip® drivers will be automatically loaded into the system memory.
5.At this time, the DiskOnChip® can be accessed as any disk drive.
6.If it is the only disk in the system, it will appear as the first drive, drive C:.
7.If there are more drives already attached to the system, then by default, the DiskOnChip® will appear as the last drive unless specially programmed.
8.If the DiskOnChip® is to be bootable, then follow the steps below
a.Use DOS command to copy the operating files into the DiskOnChip®
b.The DiskOnChip® is to be configured as the first drive, drive C: in the system. Use the DUPDATE utility.
DUPDATE D /S: DOC104.EXB /FIRST (set as c:)
DUPDATE C /S: DOC104.EXB (set as d:)
For more information and for the latest software utility and utilities manual on the DiskOnChip®, visit
APOLLO 120/150 III |
|
