Apollo 120, 150 user manual System Setup for the First-time Use, Installation Procedures

User Manual version 2007

2.2. System Setup for the First-time Use

To set up the APOLLO 120/150 for the first-time use, you should have the following items ready. The items are either in the accessory box or available in any computer stores.

u110V or 220V power cord

uPS/2 or AT keyboard or wireless keyboard

uPS/2 or serial mouse

2.2.1. Installation Procedures

The APOLLO system can be powered either by an AC electrical outlet (100~240V/5A @60Hz, 200~240V/2.5A @50Hz) or by DC power source (20~28VDC or 40~56VDC or 36~72VDC). If the system is to be powered up by AC power, be sure to use the right power cord (110V or 220V) for connection.

1.Connect the female end of the power cord to the AC inlet located at the rear bottom side of the panel PC.

2.Connect the 3-pin male end of the power cord to an electrical outlet.

3.Connect a PS/2 keyboard or an AT keyboard to keyboard port. If you are using an AT keyboard, you need an adapter (AT to PS/2 KB) for this connection.

4.Connect the PS/2 mouse to the PS/2 mouse port. If you are using a serial mouse, it can be connected to the COM port.

5.Turn on the main switch on the power supply if there is one.

6.Power on the panel PC by switching the power switch located at the rear bottom side.

APOLLO 120/150 III 2-17