User Manual version 2207

After finishing the LCD module installation, the module is to be assembled to the front bezel module, then to the chassis with the motherboard and touch controller already on.

1.Use special air blower to blow any dust between the LCD and touchscreen before the two modules are assembled together. Retain the LCD module and the front bezel module together with six 3*6 screws.

2.The LCD cable is 41-pin to 50-pin cable with around 30 cm in its length. Insert the 41-pin end into the opening at the back side of the LCD holder and have it firmly plugged to the LCD connector located at the rear side of the LCD panel.

3.Install the whole front bezel module with LCD already on to the system chassis with the motherboard, touchscreen controller and HDD module already on.

4.The LCD cable is already at the rear side of the LCD holder through the cutout. Make sure the 50 pin end is to go

through the rectangle opening at the rear side of the

system chassis. PLEASE NOTE THAT THERE IS A BROWN WIRE SWINGING OUTSIDE OF THE 50 PIN END. THIS BROWN WIRE IS ONLY TO BE WITH 12.1” SYSTEM. TAPE THE BROWN WIRE TO THE CABLE TO PREVENT IT FROM SWING AROUND TO CAUSE POSSIBLE SHORT CIRCUIRTRY.

5.Connect the LCD cable to the 50 pin LCD header

connector on the motherboard. SPECIAL ATTENTION NEEDS TO

BE PAID WHEN PLUGGING THE LCD CABLE TO THE LCD HEADER CONNECTOR ON THE MOTHERBOARD. ON THE 50 PIN END, PIN #1 IS MARKED WITH A WHITE POINT. MAKE SURE PIN 1 OF THE ONBOARD LCD CONNECTOR MATCH PIN 1 OF THE CABLE ANY WRONG PLUGGING OR SHIFTED PLUGGING WILL DAMAGE THE LCD PANEL OR LEAD TO MAL-FUNCTION.

5-64

APOLLO 120/150 III

Page 74
Image 74
Apollo 150, 120 user manual Through the rectangle opening at the rear side