User Manual version 2207
5.8. LCD Module Assembly
Figure 5-8 and 5-9 illustrate the way to assemble the APOLLO’s LCD module.
The LCD does not fix to the main system directly. Rather, it is to be fixed to a LCD holder, then to the main system. The assembly of APOLLO 120 LCD module slightly differs from that of APOLLO 150.
1.For APOLLO 120, there are two LCD brackets (Fig. 5-8 (2) & (3)) used to fix to the LCD panel to the LCD holder (11) from the up & down sides. Fix the two brackets to the LCD holder first.
2.Fix the LCD panel to the LCD holder with four 3*8 screws.
3.Attach the insulator to the invertor.
4.The invertor cable for APOLLO 120 is a 4-pin to 4-pin cable and for APOLLO 150 is a 4-pin to 7-pin cable with wafer connectors at both sides. Connect the one end of the invertor cable to invertor first. The other end is for later connection to the onboard INV1.
5.Connect the pink-white high voltage wires from the LCD the invertor.
6.The invertor for (Fig. 5-8 (9)) APOLLO 120 is to be fixed at the right middle side of the LCD holder with the up side down and for APOLLO 150 (Fig. 5-8 (7)) is at the reverse side of the LCD holder later after the LCD module is to be installed to the system..
There are other accessories to be put on the LCD module.
1.Fix 6 bronze sticks (15 mm) to the lower sides of the LCD holder. Fix the IR/LED board to the LCD holder with two 3*6 screws.
2.The two speakers (Fig.
APOLLO 120/150 III |
