User Manual version 2207
To skip the VGA graphics
INSTALL:
More than one flag may be specified, separated by spaces. Flags may be in upper or lower case.
STEP 4 - CALIBRATING THE TOUCHSCREEN
The final installation step is calibrating the touchscreen. Type "GO" when instructed. Begin the calibration sequence.
You will be prompted to touch three calibration points on the screen. Before you do so, position yourself in front of the screen in normal sitting (or standing) position, with normal height and reach.
Using your finger, touch each of the three points as they appear in the corners of the screen. The program will respond with a “beep” sound as you lift your finger from each point.
Calibration is performed in four common video modes: 80x25 text mode, CGA 320x200 graphics, VGA 320x200 graphics, and VGA 640x480.
The numerical values for the calibration points for the last video mode are displayed. X or
If the calibration program does not respond to a touch, check the cabling, the switch and/or jumper settings on the controller, and the configuration you selected when installing the software. Run SETUP to change the configuration.
| APOLLO 120/150 III |
