Vanguard Heating VMH10TN installation manual Assembling Brass Trim Brass trim shipped with mantel

Page 15

INSTALLING

Assembling Brass Trim (Brass trim shipped with mantel)

1.

Remove packaging from three remaining pieces of brass trim.

 

Continued 2. Locate two adjusting plates with set screws, and two shims in the hardware packet.

 

3.

Align shim under adjusting plate as shown in Figure 14.

 

4.

Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see

 

 

Figure 14).

 

5.

Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim

 

 

(see Figure 14).

 

6.

While firmly holding edges of brass trim together, tighten both set screws on the

 

 

adjusting plate with slotted screwdriver.

 

7.

Repeat steps 1 through 6 for other corner.

 

8.

Set Brass Assembly aside for later installation.

Top Brass Trim

Set Screws

Slot

Adjusting

 

Plate

 

Shim

Mitered Edge

Slot

Side Brass Trim

 

Figure 14 - Assembling Brass Trim

Attaching Wood Base to Solid Floor

For attaching base to solid floors (concrete or masonry)

Note: Floor anchors and mounting screws are in hardware package. The hardware package is provided with fireplace.

1.Drill holes at marked locations using 5/16" drill bit. For solid floors (concrete or masonry), drill at least 1" deep.

2.Fold floor anchor as shown in Figure 15.

Figure 15 - Folding Anchor

3.Insert floor anchor (wings first) into hole. Tap anchor flush to floor.

4.Insert mounting screws through base and into floor anchors.

5.Tighten screws until base is firmly fastened to floor.

15

103670

Image 15
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualSafety Information ContentsSafety Product FeaturesProduct Identification Local CodesAssembly Installing LogAssembling Fireplace AIR for Combustion VentilationProviding Adequate Ventilation AIR for Determining FRESH-AIR Flow for Fireplace LocationDetermining if You Have a Confined or Unconfined Space Ventilation Air From Inside Building Ventilation AIRTion and ventilation air by one of the methods described Cable local codesVentilation Air From Outdoors AIR for Combustion and VentilationLocating Fireplace InstallationInstallation Items Check GAS TypeInstallation BUILT-IN Fireplace Installation InstallingGas Supply, Mantel Clearances for Built-In InstallationAttaching Brass Trim to Fireplace Optional Mantel InstallationAttaching Wood Base to Solid Floor Assembling Brass Trim Brass trim shipped with mantelFollow all local codes ConnectingTo GAS SupplyInstallation Items Needed Connecting Fireplace to GAS SupplyConnections Pressure Testing GAS Supply Piping SystemPressure Testing Fireplace GAS Connections Checking GASFireplace Pilot Operating FireplaceShutting Off Burner Only pilot stays lit Shutting Off FireplacePilot Flame Pattern Inspecting BurnerCorrect Burner Flame Pattern Burner Flame PatternCabinet Cleaning and Maintenance Trouble ShootingObserved Possible Problem Cause Remedy ODS/PILOT and BurnerSee Cleaning TROUBLE- Shooting Top Ing statement atHints ServiceReplacement TechnicalAccessories VMH10TN Model VMH10TN Parts ListWarranty Information Limited WarrantyVENT-FREE Natural GAS Compact Classic HEARTHâ Fireplace