Vanguard Heating VMH10TN installation manual Installation

INSTALLATION	WARNING ICONG 001CAUTION
Continued	If you install the fireplace in a home garage

•fireplace pilot and burner must be at least 18 inches above floor.

•locate fireplace where moving vehicle will not hit it.

For convenience and efficiency, install fireplace

•where there is easy access for operation, inspection, and service.

•in coldest part of room.

An optional blower kit is available from your dealer. See Accessories, page 29. If planning to use blower, follow instructions provided with the blower for power source.

CAUTION

WARNING ICON G 001

This fireplace creates warm air currents. These currents move heat to wall surfaces next to fireplace. Installing fireplace next to vinyl or cloth wall coverings or operating fireplace where impurities in the air (such as tobacco smoke) exist, may discolor walls.

IMPORTANT: Vent-free fireplaces add moisture to the air. Although this is beneficial, installing fireplace in rooms without enough ventilation air may cause mildew to form from too much moisture. See Air for Combustion and Ventilation, pages 6 through 9.

CEILING

36" Minimum

6" Minimum From Sides Of Fireplace

Left	Right
Side	Side

FLOOR

Figure 6 - Mounting Clearances As Viewed From

Front of Fireplace Shown Built In The Wall

CEILING

36" Minimum

Top Of

Mantel Can

Be Flush

With Wall

Right

Side

Left

Side

Figure 7 - Mounting Clearances As Viewed From
Front of Fireplace Shown with Optional Mantel	11

103670