Vanguard Heating VMH10TN installation manual Assembly, Assembling Fireplace, Installing Log

Page 5

ASSEMBLY

WARNING

WARNING ICON

G 001

Always have branch support and screen in place before operating fireplace. This prevents excessive temperatures on fireplace surfaces.

ASSEMBLING FIREPLACE

Tools Required: Phillips screwdriver, 5/16" hex wrench, and slotted screwdriver

Installing Log

1.Remove back log, branch, and hood from log box. Discard protective packaging.

2.Remove two shipping screws above screen (see Figure 2).

3.Lift screen up and pull out to remove.

4.An optional blower is available. See Accessories, page 29. Install optional blower now. Follow installation instructions provided with blower.

5.Gently place back log on burner support (see Figure 2). The log should fit flat against top of burner support. Place two #10 one-inch-long screws through burner support into the log and tighten. Place branch on branch support (see Figure 2).

6.Reattach screen by placing the notches in the screen frame over the shoulder screws and pushing down.

Back Log

 

Screen Shipping Screw

 

Shoulder Screw

 

 

 

 

Burner

 

Screw

Support

 

 

Screw Branch

Support

Screen

Branch

 

Figure 2 - Assembling Fireplace

WARNING

WARNING ICON

G 001

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this fireplace may result in property damage or personal injury

Assembling Hood

1.Locate four black phillips sheet metal screws from the hardware packet.

2.Place hood over top edge of firebox wrapper.

3.Attach screws (see Figure 3).

Figure 3 - Assembling Hood

103670

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualSafety Information ContentsSafety Product Identification FeaturesLocal Codes ProductAssembling Fireplace AssemblyInstalling Log Providing Adequate Ventilation AIR for CombustionVentilation Determining if You Have a Confined or Unconfined Space AIR forDetermining FRESH-AIR Flow for Fireplace Location Tion and ventilation air by one of the methods described Ventilation AIRCable local codes Ventilation Air From Inside BuildingVentilation Air From Outdoors AIR for Combustion and VentilationInstallation Items InstallationCheck GAS Type Locating FireplaceInstallation BUILT-IN Fireplace Installation InstallingGas Supply, Mantel Clearances for Built-In InstallationAttaching Brass Trim to Fireplace Optional Mantel InstallationAttaching Wood Base to Solid Floor Assembling Brass Trim Brass trim shipped with mantelTo GAS ConnectingSupply Follow all local codesInstallation Items Needed Connecting Fireplace to GAS SupplyPressure Testing Fireplace GAS Connections Pressure Testing GAS Supply Piping SystemChecking GAS ConnectionsFireplace Pilot Operating FireplaceShutting Off Burner Only pilot stays lit Shutting Off FireplacePilot Flame Pattern Inspecting BurnerCorrect Burner Flame Pattern Burner Flame PatternObserved Possible Problem Cause Remedy Cleaning and Maintenance Trouble ShootingODS/PILOT and Burner CabinetSee Cleaning TROUBLE- Shooting Top Ing statement atReplacement ServiceTechnical HintsAccessories VMH10TN Model VMH10TN Parts ListVENT-FREE Natural GAS Compact Classic HEARTHâ Fireplace Warranty InformationLimited Warranty
Top Page Image Contents