Vanguard Heating VMH26TPB installation manual Assembly, Installing Log

Page 5

ASSEMBLY

WARNING

WARNING ICON

G 001

Always have branch support and screen in place before operating fireplace. This prevents excessive temperatures on fireplace surfaces.

ASSEMBLING FIREPLACE

Tools Required: Phillips screwdriver, 5/16" hex wrench, and slotted screwdriver

Installing Log

1.Remove back log, branch, and hood from log box. Discard protective packaging.

2.Remove two shipping screws above screen (see Figure 2).

3.Lift screen up and pull out to remove.

4.An optional blower is available. See Accessories, page 32. Install optional blower now. Follow installation instructions provided with blower.

5.Gently place back log on burner support (see Figure 2). The log should fit flat against top of burner support. Place two #10 one-inch-long screws through burner support into the log and tighten. Place branches on branch support (see Figure 2).

6.Reattach screen by placing the notches in the screen frame over the shoulder screws and pushing down.

Back Log

 

Screen Shipping Screw

 

Shoulder Screw

 

 

 

 

Burner

 

Screw

Support

 

 

Screw Branch

Support

Screen

Twig

 

Figure 2 - Assembling Fireplace

WARNING

WARNING ICON

G 001

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this fireplace may result in property damage or personal injury

Assembling Hood

1.Locate four black phillips sheet metal screws from the hardware packet.

2.Place hood over top edge of firebox wrapper.

3.Attach screws (see Figure 3).

Figure 3 - Assembling Hood

5

 

102886

Page 4 Page 6
Image 5
Page 4 Page 6
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualContents Safety Information Safety Information Safety Pilot Local Codes Product Features UnpackingPiezo Ignition System Thermostatic Heat ControlInstalling Log AssemblyProviding Adequate Ventilation AIR for Combustion and VentilationUnusually Tight Construction Confined and Unconfined SpaceDetermining if You Have a Confined or Unconfined Space Determining FRESH-AIR Flow for Fireplace LocationVentilation Air From Inside Building Ventilation AIRVentilation Air from Outdoors Shown with Optional Mantel Ventilation Air From OutdoorsInstallation Items InstallationCheck GAS Type Locating FireplaceCeiling BUILT-IN Fireplace Installation InstallingSide Firebox Mantel Shelf Mantel Clearances for Built-In InstallationAttaching Brass Trim to Fireplace Optional Mantel InstallationAttaching Wood Base to Solid Floor Assembling Brass Trim Brass trim shipped with mantelExternal Regulator with Vent Pointing Down Connecting to GAS SupplyInstallation Items Needed Connecting Fireplace to GAS SupplyPressure Testing GAS Supply Piping System Connecting to GAS Supply Checking GAS ConnectionsManual Shutoff Valve Pressure Testing Fireplace GAS ConnectionsOperating Fireplace Pilot Shutting Off Burner Only pilot stays lit Shutting Off FireplacePilot Flame Pattern Inspecting BurnerCorrect Burner Flame Pattern Burner Flame PatternCabinet Cleaning and Maintenance Trouble ShootingODS/PILOT and Burner TROUBLE- Shooting See CleaningObserved Possible Remedy Problem Cause Connections, Ing statement at topService Hints Technical ServiceParts Under Warranty Parts Not Under WarrantyVMH26TP Model VMH26TP Parts ListValve GA5010 AccessoriesGA3400T Unfinished GM921U Finished GM920F102886 102886 102886 Keep this Warranty Warranty Information
Top Page Image Contents