OPERATING HEATER
Continued
TO SELECT
HEATING LEVEL
WARNING: When running heater, set control knob at LOW, MEDIUM, or HIGH locked posi- tions. Never set control knob between locked positions. Poor combustion and higher levels of carbon monoxide may result.
CAUTION: Do not try to ad- just heating levels by using the equipment shutoff valve.
Slightly press in control knob and turn coun-
terclockwise
to the LOW, MED, or HI positions (see Figure 21).
IMPORTANT: Release downward pressure while turning control knob. Control knob will lock at the desired position.
Control | VN18A | VN30A | ||||
Knob | VP16A | VP26A | ||||
|
|
| H |
|
|
|
|
|
| I |
|
|
|
MED |
|
|
|
|
|
|
LOW |
|
|
|
|
|
|
| PILO | T | OFF |
|
| |
|
|
|
|
|
| LOW |
HI |
|
|
|
|
| |
MED |
|
|
|
|
|
|
LOW |
|
| FFO |
|
| |
| PILOT |
|
|
| ||
|
|
|
|
|
| |
|
|
|
|
|
| MED |
|
|
|
| FFO |
|
|
HI |
|
|
|
|
|
|
|
|
|
| TO |
|
|
M | ED |
| W | LIP |
|
|
|
|
| LO |
|
|
|
|
|
|
|
|
| HI |
ILO |
|
| LO |
|
| |
P |
| W |
|
|
| |
| T | MED |
|
| ||
|
|
|
|
|
| |
OFF |
|
|
|
|
|
|
|
|
|
| IH |
|
|
OFF
Figure 21 - Burner Patterns for Non-
Thermostat Models
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
1. Turn control knob clockwise 
to the OFF position.
2.Turn off all electric power to the appliance if service is to be performed.
Shutting Off Burner Only (pilot stays lit)
Turn control knob clockwise 
to the PILOT position.
MANUAL LIGHTING
PROCEDURE
1.Remove front panel (see Figure 7, page 8).
2.Follow steps 1 through 5 under Lighting In- structions, page 14.
3.With control knob pressed in, strike match. Hold match to pilot until pilot lights.
4.Keep control knob pressed in for 30 sec- onds after lighting pilot. After 30 seconds, release control knob. Now follow step 8, under Lighting Instructions, page 14.
5.Replace front panel.
THERMOSTAT MODELS
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service tech- nician or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified ser- vice technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
www.desatech.com | 15 |