Karcher 600 CD manual Introduction Marking of Instructions, Intended Use

Page 7

WTC 600 LP / MP

GENERAL

1 General

1.1Introduction

This service manual contains basic instructions and information which are to be observed upon set-up, operation and maintenance.

Therefore, it is imperative that the service manual is read by the installer as well as by the responsible specialist staff prior to installation and starting of operation. Please observe not only the general safety instructions listed in the section “Safety Instructions”, but also the special safety instructions included in the other sections.

1.2Marking of Instructions

CAUTION

NOTE

The safety instructions contained in these operating instructions, which in case of non-observance can cause dangerous situations for persons, are specially marked with the general symbol for dange.

The safety instructions contained in these operating instructions, which in case of non-observance can cause poisoning, cauterizing, etc. for persons, are specially marked with the death’s-head symbol.

Following this symbol are recommendations or tips which make working easier and provide for secure operation.

Following this symbol are recommendations or tips which make working easier and provide for secure operation.

Instructions that are attached directly to the equipment must be observed under all means and kept in completely readable condition.

1.3Intended Use

The equipment is intended for the conditioning of untreated water into drinking water.

The retention degree of harmful chemical substances and biological pathogens or contaminants is very high.

The quality of the produced drinking water ultimately depends on the contamination degree and salt content of the untreated water.

-Prior to the initial starting of operation, we recommend carrying out an analysis of the untreated water.

-Continuous drinking-water quality can be ensured only when the equipment is controlled regularly.

-The respective national or international drinking water regulations are to be observed.

Under consideration of these rules of conduct, water produced from this system can quite safely be classified as drinking water.

Service Handbook 08.2004

7

Image 7
Contents LP/MP, PI Foreword ForewordWTC 600 LP / MP Contents2.5 MaintenanceMalfunction, Cause and Corrective Action Maintenance PlanWTC 600 LP / MP Intended Use Introduction Marking of InstructionsSafety Instructionse Milliliter = 1 liter 1000 mg = General installation notesUnits and Designations Handling Electricity / Protection ClassOverview Overview of components Service HandbookDescription Flow Diagram Flocculation Module Description of the SystemModular Design Pre-chlorination ModuleAnti Scalant and Post Chlorination Mediafilter- and Activated Carbon FilterRO System, Pump and Fine Filter Control Panel and DisplayPressure-increase Pump Safety Installations Emergency StopRC Protective Switch Motor Protection SwitchMicrofuses Operating Modes Automatic Operation Standard Operating ModeManual Operation Parameter WTC 600 LP WTC 600 MP Technical Data WTC 600 LP/MPDimensions H x W x D Weight in delivery condition without filter containerFilter amounts, activated carbon filter Float SwitchFilter Container Filling capacities, MediafilterProduct ItemNo Cleaning Chemicals Product Item NoConsumption Materials Chemicals for Metering ContainerAssembly Chapter Assembly and Starting OperationStarting Operation Chapter First fill of the metering tanks Mixing Chlorine, Flocculation Agent and AntiscalantPre-chlorination Calculation example Antiscalant Work Steps Mixing of the flocking test solution AuxiliariesMetering Amounts and Mixing of the Post Chlorination Flocculation AgentEvaluate flocking test Perform flocking test AuxiliariesConnections, Valves and Indicators Connecting the EquipmentRO Module with Preliminary Filters Pressure-increase ModulePreliminary Filter Electrical Connections Pressure-increase PumpMetering Station WTC 600 LP / MP Reverse Osmosis System Starting OperationModul Lift Frequency Meter 14/1 14/4 Ing Backwashing / Regeneration Initial FillingMedia and Activated Carbon Filter Filter Support pebbles Filter sand / Activated carbonPosition Indication Description ProgrammingIndication Description Menu Selection Technician passwordUser Level Technician LevelDe-conserving Adjusting Operating Parameters and Balancing ValuesSelecting Several Arguments at the Same Acknowledging Data InputsIndication System in disinfection operating mode Untreated Drinking water Concentrade Yield Water Capacity Initial startupKeys to call up menu item 6 LF limits User indication in normal operation Normal OperationOperating Messages for Normal Operation Putting Out of Operation Desinfection Metering Station WTC 600 CD Fine FilterEvery 4 weeks Replacing the membrane RO Filter ReplacementFilter replacement Reverse Osmosis Module RO ModuleAssembly and disassembly of the RO filter Cleaning in Case of MalfunctionAids Design of the Flushing and Disinfection EquipmentStarting Position Work Steps Disinfection Acidic and Alkaline Cleaning Conserve the RO system Starting Position Drain the pre-filter Flushing the pre-filter Spare parts required Replace the activated carbon or filter sandSpare parts possibly required Disposing of the replaced filter material Indication Malfunction Cause Corrective Action Chap Malfunction, Cause and Corrective ActionMalfunction Indication at the Operating Panel Indication of RO Fuse defective Have replaced by Chap./Fig Maintenance Plan Maintenance Plan Service Module Work to be Carried Out Other MaintenanceGWV RO control factory settingsWTC 600 MP, MP-A, MP-AM in voltages 230 V and 400 Operating mode Switched offRO control program structure Appendix RO 1000 Manual ManualContents Technical Data Scope of Application General RemarksInstructions for Use Safety InstructionsDeclaration of Conformity Terms and DefinitionsScript Examples Start-up Code Function Adm. max. load Terminal Function of TerminalsNot switch off Operational Scope Operating settingsLIM Operating parametersAppendix Stop Operating conditions Forced Stop active Pressure Switch activeOperating failures/failure messages Denomination Reason ConsequenceText display Indicator lightsOperation User interface KeyboardSelection Password entryBasic elements Selection of menuConfirmations MultiselectionNumerical editing Alphanumerical editingTechnicians level Operating levelsUsers Level Menu structure Menu point Function Main menuMax Cy Calibration menuDiagnosis menu Setting menuMin Type Max Unit Technical DataOperating Record for the WTC 600 LP/MP Automatic Operation List of KEY Words Units and Designations

600 CD specifications

The Karcher 600 CD is an innovative cleaning machine designed to tackle a wide variety of dirt and grime in both professional and domestic settings. Renowned for its efficiency, versatility, and user-friendly design, this powerful equipment is particularly well-suited for cleaning large areas such as driveways, patios, and commercial spaces.

One of the standout features of the Karcher 600 CD is its robust pressure cleaning capability. It boasts a maximum pressure output that effectively removes stubborn stains, embedded dirt, and even algae with minimal effort. The adjustable pressure settings offer the flexibility needed for different surfaces, ensuring that delicate materials are not damaged while still achieving optimal cleaning results.

The Karcher 600 CD employs advanced cleaning technologies such as the patented Dual Nozzle System. This feature ensures a consistent and thorough clean by utilizing two high-pressure nozzles that work in unison. The nozzles are adjustable, allowing users to customize the spray pattern according to the task at hand. Whether it’s rinsing large surfaces or precision cleaning in tight spots, the Karcher 600 CD excels in delivering superior results.

In terms of ergonomics, the Karcher 600 CD is designed for user comfort. It features a lightweight and compact build that allows for easy maneuverability, even in hard-to-reach areas. The integrated handle and wheels enhance portability, making it effortless to transport the machine from one location to another.

Energy efficiency is another key characteristic of the Karcher 600 CD. The machine is engineered to consume less water and energy while still providing powerful cleaning performance. This eco-friendly aspect not only reduces operational costs but also aligns with sustainable cleaning practices.

Furthermore, the Karcher 600 CD comes with a range of accessories and attachments that enhance its functionality. Users can switch between different cleaning tasks seamlessly, whether it’s washing vehicles, cleaning decks, or revitalizing outdoor furniture.

The Karcher 600 CD stands out in the cleaning equipment market for its combination of power, versatility, and efficiency. With its user-centric design and advanced features, it is ideal for homeowners and professionals alike who seek effective and reliable cleaning solutions.