Karcher manual Fine Filter, Metering Station WTC 600 CD, Every 4 weeks

Page 43

WTC 600 LP / MP

MAINTENANCE

4 Maintenance

4.1Fine Filter

The manometers (17/1 and 17/3) are located in front of and behind the fine filter unit (17/2). If the differential pressure is more than 0.8 bar, the fine filter is to be cleaned or replaced:

-Stop the untreated water supply until the system is in the lack of pressure operating condition.

-Switch off the main switch.

-Release the pressure in the equipment (open the sampling valve for untreated water).

-Replace filter.

NOTE Replace the fine filter every 3 months.

NOTE Use the special filter wrench!

1 2 3

Figure 17 Replacing the fine filter

4.2Metering Station WTC 600 CD

Every 4 weeks:

Clean the inside of the metering tank and thoroughly rinse with chlorine-free drinking water.

When working on the metering head or on the connections and lines, wear protective clothing (goggles, gloves)!

Before any maintenance, disconnect the pump from mains (pull mains plug)!

Every 12 months (or when malfunctions occur):

Cleaning the suction and pressure valves

-Unscrew valve and take out inner part of valve.

-With a thin wire pin (nail or similar), carefully remove the valve inner part in flow direction (see arrow mark on valve body).

-Disassemble the inner part (seat, O-ring, balls, ball cages) and clean; replace if necessary.

-Reassemble valve again and screw in.

CAUTION Observe direction of flow (arrow)!

Tighten valve by hand only (danger of damaging!)

1)Feinfilter 5µ: Art.-Nr. 6.414-466.0

Service Handbook 08.2004

43

Image 43
Contents LP/MP, PI Foreword ForewordWTC 600 LP / MP Contents2.5 MaintenanceMalfunction, Cause and Corrective Action Maintenance PlanWTC 600 LP / MP Intended Use Introduction Marking of InstructionsSafety Instructionse Milliliter = 1 liter 1000 mg = General installation notesUnits and Designations Handling Electricity / Protection ClassOverview Overview of components Service HandbookDescription Flow Diagram Flocculation Module Description of the SystemModular Design Pre-chlorination ModuleAnti Scalant and Post Chlorination Mediafilter- and Activated Carbon FilterRO System, Pump and Fine Filter Control Panel and DisplayPressure-increase Pump Safety Installations Emergency StopRC Protective Switch Motor Protection SwitchMicrofuses Operating Modes Automatic Operation Standard Operating ModeManual Operation Parameter WTC 600 LP WTC 600 MP Technical Data WTC 600 LP/MPDimensions H x W x D Weight in delivery condition without filter containerFilter amounts, activated carbon filter Float SwitchFilter Container Filling capacities, MediafilterProduct ItemNo Cleaning Chemicals Product Item NoConsumption Materials Chemicals for Metering ContainerAssembly Chapter Assembly and Starting OperationStarting Operation Chapter First fill of the metering tanks Mixing Chlorine, Flocculation Agent and AntiscalantPre-chlorination Calculation example Antiscalant Work Steps Mixing of the flocking test solution AuxiliariesMetering Amounts and Mixing of the Post Chlorination Flocculation AgentEvaluate flocking test Perform flocking test AuxiliariesConnections, Valves and Indicators Connecting the EquipmentRO Module with Preliminary Filters Pressure-increase ModulePreliminary Filter Electrical Connections Pressure-increase PumpMetering Station WTC 600 LP / MP Reverse Osmosis System Starting OperationModul Lift Frequency Meter 14/1 14/4 Ing Backwashing / Regeneration Initial FillingMedia and Activated Carbon Filter Filter Support pebbles Filter sand / Activated carbonPosition Indication Description ProgrammingIndication Description Menu Selection Technician passwordUser Level Technician LevelDe-conserving Adjusting Operating Parameters and Balancing ValuesSelecting Several Arguments at the Same Acknowledging Data InputsIndication System in disinfection operating mode Untreated Drinking water Concentrade Yield Water Capacity Initial startupKeys to call up menu item 6 LF limits User indication in normal operation Normal OperationOperating Messages for Normal Operation Putting Out of Operation Desinfection Metering Station WTC 600 CD Fine FilterEvery 4 weeks Replacing the membrane RO Filter ReplacementFilter replacement Reverse Osmosis Module RO ModuleAssembly and disassembly of the RO filter Cleaning in Case of MalfunctionAids Design of the Flushing and Disinfection EquipmentStarting Position Work Steps Disinfection Acidic and Alkaline Cleaning Conserve the RO system Starting Position Drain the pre-filter Flushing the pre-filter Spare parts required Replace the activated carbon or filter sandSpare parts possibly required Disposing of the replaced filter material Indication Malfunction Cause Corrective Action Chap Malfunction, Cause and Corrective ActionMalfunction Indication at the Operating Panel Indication of RO Fuse defective Have replaced by Chap./Fig Maintenance Plan Maintenance Plan Service Module Work to be Carried Out Other MaintenanceGWV RO control factory settingsWTC 600 MP, MP-A, MP-AM in voltages 230 V and 400 Operating mode Switched offRO control program structure Appendix RO 1000 Manual ManualContents Technical Data Scope of Application General RemarksInstructions for Use Safety InstructionsDeclaration of Conformity Terms and DefinitionsScript Examples Start-up Code Function Adm. max. load Terminal Function of TerminalsNot switch off Operational Scope Operating settingsLIM Operating parametersAppendix Stop Operating conditions Forced Stop active Pressure Switch activeOperating failures/failure messages Denomination Reason ConsequenceText display Indicator lightsOperation User interface KeyboardSelection Password entryBasic elements Selection of menuConfirmations MultiselectionNumerical editing Alphanumerical editingTechnicians level Operating levelsUsers Level Menu structure Menu point Function Main menuMax Cy Calibration menuDiagnosis menu Setting menuMin Type Max Unit Technical DataOperating Record for the WTC 600 LP/MP Automatic Operation List of KEY Words Units and Designations

600 CD specifications

The Karcher 600 CD is an innovative cleaning machine designed to tackle a wide variety of dirt and grime in both professional and domestic settings. Renowned for its efficiency, versatility, and user-friendly design, this powerful equipment is particularly well-suited for cleaning large areas such as driveways, patios, and commercial spaces.

One of the standout features of the Karcher 600 CD is its robust pressure cleaning capability. It boasts a maximum pressure output that effectively removes stubborn stains, embedded dirt, and even algae with minimal effort. The adjustable pressure settings offer the flexibility needed for different surfaces, ensuring that delicate materials are not damaged while still achieving optimal cleaning results.

The Karcher 600 CD employs advanced cleaning technologies such as the patented Dual Nozzle System. This feature ensures a consistent and thorough clean by utilizing two high-pressure nozzles that work in unison. The nozzles are adjustable, allowing users to customize the spray pattern according to the task at hand. Whether it’s rinsing large surfaces or precision cleaning in tight spots, the Karcher 600 CD excels in delivering superior results.

In terms of ergonomics, the Karcher 600 CD is designed for user comfort. It features a lightweight and compact build that allows for easy maneuverability, even in hard-to-reach areas. The integrated handle and wheels enhance portability, making it effortless to transport the machine from one location to another.

Energy efficiency is another key characteristic of the Karcher 600 CD. The machine is engineered to consume less water and energy while still providing powerful cleaning performance. This eco-friendly aspect not only reduces operational costs but also aligns with sustainable cleaning practices.

Furthermore, the Karcher 600 CD comes with a range of accessories and attachments that enhance its functionality. Users can switch between different cleaning tasks seamlessly, whether it’s washing vehicles, cleaning decks, or revitalizing outdoor furniture.

The Karcher 600 CD stands out in the cleaning equipment market for its combination of power, versatility, and efficiency. With its user-centric design and advanced features, it is ideal for homeowners and professionals alike who seek effective and reliable cleaning solutions.