Allied Air Enterprises A95UH, 95G1UH NON-DIRECT Vent Roof Termination KIT, Condensate Piping

NON-DIRECT VENT ROOF TERMINATION KIT

(15F75 or 44J41)

Figure 37

NON-DIRECT VENT FIELD SUPPLIED WALL

TERMINATION

Figure 38

3.If exhaust piping must be run up a sidewall to position above snow accumulation or other obstructions, piping must be supported every 24” (610 mm) as shown in Figure 39. When exhaust piping must be run up an outside wall, any reduction in exhaust pipe size must be done after the final elbow.

NON-DIRECT VENT FIELD SUPPLIED WALL

TERMINATION EXTENDED OR (15F74)

WALL TERMINATION VENT PIPE EXTENDED

*Use wall support every 24” (610 mm). Use two supports if extension is greater than 24” but less than 48”.

Figure 39

NON-DIRECT VENT APPLICATION

USING EXISTING CHIMNEY

NOTE: Do not discharge exhaust gases directly into any chimney or vent stack. If vertical discharge through an existing unused chimney or stack is required. Insert piping inside chimney until the pipe open end is above top of the chimney and terminates as illustrated. In any exterior portion of chimney, the exhaust vent must be insulated.

Figure 40

Condensate Piping

This unit is designed for either right or left side exit of condensate piping in upflow applications. In horizontal applications, the condensate trap must extend below the unit. An 8” service clearance is required for the condensate trap. Refer to Figure 41 for condensate trap locations.

Page 28 of 48 Issue 1031 506501-01