Whirlpool AD50USS, AD50DSS Draining the Dehumidifier, Desired Humidity Control Type 3 Models Only

Page 14

•Auto —Will provide the maximum humid- ity control by automatically adjusting the fan speed and/or turning the dehumidiﬁer on and off to maintain humidity setting.

Desired Humidity (Control Type 3 Models Only)

1.Press DESIRED HUMIDITY to select the desired humidity setting.

2.Choose Normal, Dry, Max Dry or Continu- ous Run.

•Normal—Will operate the dehumidiﬁer at the selected fan speed until the humidity levels are lowered.

•Dry—Will operate the dehumidiﬁer at the selected fan speed until the humidity levels are lowered more than the Normal setting.

•Max Dry—Will operate the dehumidiﬁer at the selected fan speed until the humid- ity levels are lowered to the maximum level.

•Continuous Run—Will operate the dehu- midiﬁer continuously at the selected fan speed regardless of humidity level.

If Auto fan speed is selected, the fan will operate at the High speed setting. The dehumidiﬁer will turn off only if the bucket is full or removed.

NOTE: The Deicer will turn off the com- pressor if a low temperature condition exists. Pressing the Desired Humidity arrow will not increase or decrease the amount of moisture removed. Compres- sor operation will resume when the low temperature condition no longer exists.

DRAINING THE DEHUMIDIFIER

Sickness Hazard

Do not drink water collected in water bucket.

Doing so can result in sickness.

Option 1—Remove Bucket

If a ﬂoor drain is not available, or you do not plan to run the dehumidiﬁer continuously, you may want to simply empty the bucket.

1. Use front handle to slide bucket out.

2. Use front and back handles to lift bucket.

2-6

Image 14

Contents Dehumidifiers Models AD25BSS, AD35DSS, AD50DSSForward Goals and ObjectivesTable of Contents Page You can be killed or seriously injured if you don’t Dehumidifier SafetyGeneral Immediately follow instructionsSerial Number Model & Serial Number DesignationsModel Number AD = Dehumidiﬁer, Whirlpool RD = Dehumidiﬁer, RoperModel & Serial Number Wiring Diagram Label Locations Page Theory of Operation What is HUMIDITY?Product Operation Removing Unwanted HumidityOperating Characteristics Typical OperationPage Starting/Stopping the Dehumidiﬁer Control Type Empty/Adjust Bucket LightDehumidifier USE Fan Speed Control Type 2 Models OnlyFan Speed Control Type 3 Models Only Dryness ControlStarting/Stopping the Dehumidiﬁer Draining the Dehumidifier Desired Humidity Control Type 3 Models OnlyNormal Sounds Option 2-Connect Drain HoseDehumidifier Care Cleaning the AIR Filter on Some ModelsCleaning the Dehumidifier Component Access Component LocationsRemoving the Cabinet Top Rear Screws Rear Half Front Half Bottom Rear Screw Remove the two hex-head screws from the electronic control Thermistor & Clip Ground Wire Screw To remove the mechanical humidistat To remove the lightTo remove the power supply cord To remove the fan motor Removing the FAN Capacitor and the FAN MotorTo remove the fan capacitor see the top right photo Top green ground wire on condenser Removing the Compressor Capacitor and the Bucket Switch To remove the compressor capacitorTo remove the bucket switch Electronic Model Mechanical ModelsPage Component Testing Mechanical Humidistat FAN CapacitorBucket Switch FAN MotorDiagnostics & Troubleshooting DiagnosticsTroubleshooting Problem Cause CorrectionWiring Diagrams Wiring DiagramWiring Diagram Wiring Diagram Page Page Page For Technical Assistance While AT the CUSTOMER’S Home Call Product Specifications Warranty Information SourcesFor Technical Information and Service Pointers Corporation