DMP Electronics XR500 11.6, Panic Alarm Output, 11.7 11.8, Ambush Output, Entry Output, 11.9

Output Options

11.6

PANIC ALM out: 0

Panic Alarm Output

Enter the output number to turn on when any Panic type zone is placed in an alarm condition. The output is turned off after all Panic zones are restored from an alarm condition and a Sensor Reset is performed. Enter 0 (zero) to disable.

Wireless Outputs

•The Panic Alarm is compatible with the Model 1118 Wireless Remote Indicator Light and the Model 1116 Wireless Relay Output connected to a Model 572 Indicator LED.

•When a Panic Alarm occurs, the LED turns on steady for five minutes and then turns off.

•When a Panic Test is initiated from the keypad, the LED flashes quickly for five minutes.

•For a Panic Alarm, a fast response wireless output number is recommended.

11.7

11.8

Ambush out:	0
Entry out:	0

Ambush Output

Enter the output number to turn on when an Ambush code is entered at a keypad. The output is turned off using the Sensor Reset option. Enter 0 (zero) to disable.

Entry Output

Enter the output number to turn on at the start of the entry delay time. The output turns off when the area is disarmed or the entry delay time expires. Enter 0 (zero) to disable.

11.9

Exit out: 0

Exit Output

Enter the output number to turn on when an exit delay time starts in any area of the system. The output turns off when the area arms or when the arming has been stopped. Enter 0 (zero) to disable.

11.10

		Ready Output
Ready out:	0	Enter the output number to turn on when all disarmed burglary zones are in a
		normal state. The output is turned off when any disarmed burglary type zone is in
		a bad state. Enter 0 (zero) to disable. This output is not compatible with Cutoff
		Outputs.

11.11

11.12

Ph trbl out:	0
Late cls out:	0

Telephone Trouble Output

Enter the output number to turn on when the phone line monitor on the panel phone line is lost. Enter 0 (zero) to disable this output.

Late To Close Output

Enter the output number to turn on at the expiration of a Closing schedule. The output activates simultaneously with the CLOSING TIME! keypad display. The output is turned off when the area is armed, the Closing is extended, or the schedule is changed. Enter 0 (zero) to disable this output.

11.13

11.14

		Device Fail Output
dvc fail out:	0	Enter the output number to turn on when an addressed device fails to respond to
		polling from the panel. A Missing Device report is sent to the receiver. The output
		is turned off when the device responds to polling or is removed from programming in
		the system. Enter 0 (zero) to disable this output and LX-Bus™ device fail reporting
		to the receiver. If any addressed device is unsupervised, this output cannot be used.

Sensor Reset Output

snsr rst out: 0 Enter the output number to turn on when a Sensor Reset is performed at a keypad. The output turns off automatically 5 seconds later. This function can be used to reset smoke detectors that are operated by an external power supply through a Model 716 Output Expander Module. Enter 0 (zero) to disable this output.

Digital Monitoring Products XR500 Series Canadian Programming Guide

34