DMP Electronics XR500 18.5 18.6 18.7 18.8 18.9 18.10, Closing Check, Closing Code, Any Bypass

18.5

18.6

18.7

18.8

18.9

18.10

CLs Chk no YES

Cls Code no YES

Any Byps no YES

Area sch no YES

Early Ambush: 0

Area No: -

Area Information

Closing Check

Select YES to enable the panel to verify that all areas in the system are armed after permanent or extended sched­ules ex­pire. If the Clos­ing Check finds any areas disarmed past the sched­uled time, the keypads selected to display System Trouble Status displays CLOSING TIME! and emits a steady beep. When Area Schedules is set to YES in Area Information, the specific area and name display followed by — LATE.

When Auto Arm is NO, if within ten minutes the system is not armed or if the schedule is not extended, a Late to Close report is sent to the SCS‑1R Receiver. When Auto Arm is YES, the area arms. See Automatic Arming section.

If the area becomes disarmed outside of any schedule, the Closing Check sequence occurs after the Late Arm Delay time. See Late Arm Delay.

When Closing Check is NO and Auto Arm is YES, the system immediately arms when the schedule expires. No warning tone occurs.

In addition, when Closing Check is NO, the option to extend a schedule does not display when the schedule expires.

Closing Code

When YES is selected, a code number is required for system arming. If NO is selected, a code number is not required for system arming.

Any Bypass

When YES is selected, zones can be bypassed without a code number during the arming sequence. A code number is always required to use the Bypass Zones option from the menu.

Area Schedules

Select YES to allow each area to set its own shift schedules 1 to 4. Enter NO to provide one set of schedules for this system.

Note: Area Schedules are not designed to operate with All/Perimeter or Home/ Sleep/Away systems.

Early Morning Ambush (XR500N/XR500E only)

Enter the number of minutes (1 to 15) before a silent alarm (Early Morning Ambush S33) is sent to the central station using the area 1 account number. Enter 0 (zero) to disable this option.

When a user code is entered to disarm area 1 at a keypad or reader with Access Areas assigned to area 1, the same or different user code must be entered within the programmed number of minutes to prevent an ambush message from being sent to the receiver. The second user code also must have authority to disarm area 1.

In addition, a zone activation with Alarm Action Message C also cancels the Early Morning Ambush timer and stops an Ambush message from being sent to the receiver. See Report to Transmit section in Zone Information.

The keypad does not display any indication that the ambush timer is running.

Indications can be provided by assigning an output number to Entry Out and Ambush Out in Output Options. Entry Out turns on one minute before the timer expires and turns off at expiration. Ambush Out turns on at the timers’ expiration and turns off when Sensor reset is performed.

Area Number

Enter the number of the area to program. After entering the area number, press COMMAND to enter the area name. Only Area systems allow the area name to be changed.

Note: When All/Perimeter or Home/Sleep/Away is selected as the system type, the Area Number does not display.

18.10.1

int perim

All/Perimeter Programming

When All/Perimeter is selected as the system type, program the Interior and Perimeter areas as needed.

XR500 Series Canadian Programming Guide Digital Monitoring Products

45