Kenmore 116.25812 owner manual Agitator Assembly, To Clean Agitator, To Replace Belt

TO CLEAN AGITATOR:

NOTE: In order to keep cleaning efficiency high and to prevent damage to your vacuum cleaner, the agitator must be cleaned every time the belt is chart eg__d

The agitator must also be cleaned accord- ing to the following schedule:

Vacuum Cleaner Use Clea__l__n_A_itator

2.Place agitator

assembly back into Power-Mate e

HEAVY -		every week
(used	daily)
MODERATE -		every	month
(used 2-3 times/week)
LIGHT	-	every	2 months
(used	1 time/week)

front	of
3. Line up		./__J_"!"_///'_"
cover	and
cover	on	_	_(_I_
baseoRest
front	edge	"%Z'Z.Z_.z-z_
shown.
of base as		Co ! er	Base

!)!_

_!!!_;

':::-=";_"

!i;';il?!_--;!'__,,_-,,

IMPORTANT

Disconnect vacuum cleaner from electrical outlet. Check and remove hair, string and lint build-up frequently in the Power-Mate ® agitator and end cap areas.

4, NOTE: On dirt sensor models be sure _t'_;:::_.::; that the board is upright and the wires are

tucked back in place.

Remove any dirt or debris in the belt path area or in the brush roller area.

Carefully remove any string or debris located on the agitator or end caps,

AGITATOR ASSEMBLY

Belt Pulley q

"-..Tj,"-r / Cap

Brush Unit

TO REPLACE BELT

1.Install new belt over

motor drive,		r
then	over
belt	pulley

Agitator End Cap

NOTE: See PARTS AND FEATURES for Belt number.

]

back.	Press
cover	firmly		until		"
side	and	rear			,, ,! - "_
tabs	snap	into			.... -_ ._
5. Rotata		cover
place,
Make	sure		there	Side	Rear
is no	gap			Latch	Latches

between the cover and base

6.Turn Power-Mate®upside down and replace two (2) cover screws,

19