INSTALLATION REQUIREMENTS INSTALLATION HARDWARE
Yoursir conditionerwillirrstalintostandarddoublehung
w_ndowswith_ctuatclearopeningwidthsof 23 to38inches (584mmto914mm)(FIG,1),
Lowersash must open sufficientlyto allow a e_eer vertical opening of t_5inches(381mm), Side louvers and the rear of the alr conditionermust have clear
air space to allow enoughairflow throughthe condenserfor heat removal.The rear of the unit
must be outdoors,not insidea building or garage,
I I | Sash |
| ,_ | Exterior |
lnlet_orw_1%J | ," | RG, t |
ELECTRICAL SERVICE
Check your available electrical service. The power st@plyavalabte must be the same as that shown on the unit nameplate (foundon dght side of Pab_net).
All models are equipped with a
to provide proper service and safe positive
grounding. Do not change plug in any w_y. Do not use an adapter plug, if your present wal outlet does not match your plug, c81 a qualfied electrician to
make the necessart correc4_ons,
SAVE CARTON and this OWNER'S MANUAL for
future reference. The Patton Is the best way to store unit during wfnter or when not in use.
To avoid risk of personal injury,property damage, or product damage due to the weightof this
device and sharp edges that may be exposed:
• Air conditioners coveredin thismanual pose an
excessive weighthazard. Two or more peopfe are needed to move and install the unit
To prevent injuryor strain, use proper lifting and car_ing techniques when moving unit
. Carefuly inspect iocalon where air conditioner
willbe instaled. Be sure tt willsupport the weightof the unt over an extended period of
time,
-Handle air conditioner with care, Wear protective gloves wheneverliftingor carryingthe
unit. AVOID the sharp motet fins of front and rear coils.
,Make sure air conditioner does not fall during installation.
| NAME OF PARTS |
|
A | SIDE CURTAIN | 2 |
B | SILL SUPPORT | 2 |
C | BOLT | 2 |
D | LOCK NUT | 2 |
E | SCREW: 25164" | 13 |
F | SCREW: 5/8" | 3 |
G | SCREW: 5/8" | 5 |
H | FOAM STRIP | 1 |
FOAM SEAL | i | |
J | L BRACKET | t 1 |
REQUIRED TOOLS:
=Tight Filing gloves ,'Standard screwdrive_
-Phillips screwdriver , Pliers
-Sharp knife
•3tSAnch open end wrench or adjustable wrench
.
Tape measure
-Bectric drill
•