Lighting Instructions, To IGNITE and | New Buck Corporation 1110

LIGHTING INSTRUCTIONS

1.STOP! Read the safety information on the previous page.

2.Make sure manual shutoff valve is fully closed.

3.Open access panel door, located in lower front center of base for access to control knobs.

4.Turn off all electric power to the appliance.

5.Set thermostat (flame control) to lowest setting.

6. Push in and turn control knob clockwise	to the “OFF” position.

	PILOT

		2	1
FLAME		2	1		ON
				MERTIK MAXITROL


CONTROL	4	5	7 6
	3

FIGURE 3

IGNITE

OFF

CONTROL KNOB

7.“Wait (5) five minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow step “B” in the safety information on the previous page. If you don’t smell gas, go to the next step.”

8.Find Pilot: follow the small metal tube from the right hand rear of the gas control valve.


	The pilot is located behind the burner tube and in front of the rear log. Fully open the
	manual shut-off valve.	to the “PILOT” position. Press in
9.	Turn control knob counterclockwise
	control knob for (15) fifteen seconds (see figure 3).		to IGNITE and
10.	With control knob pressed in, turn control knob clockwise

then immediately back to PILOT with the button still pressed in. This will light the pilot. If needed, keep repeating this step until pilot lights.

11.Keep control knob pressed in for one (1) minute after lighting pilot. After (1) minute, release the control knob. If pilot goes out, repeat steps 1 through 9.

•If the knob does not pop up when released, stop and immediately call your service techni- cian or gas supplier.

•“If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call

	your service technician or gas supplier.”		to “ON” position.
12.	Turn control knob counterclockwise			for “LOW”
13.	“Set thermostat (flame control) to desired setting. Turn clockwise
	and counterclockwise	for “HIGH”.

LIGHTING INSTRUCTIONS

to IGNITE and

for “LOW”

for “HIGH”.