Desa HDCFTP, HDCFTN, CGCFTP, CGCFTN Installing Blower Assembly, Models Cgcftp and Cgcftn

	INSTALLation		6. Route the wire harness through the hole in
	Continued		left side of baffle. Pull wire harness through
			lower opening above where the valve shield
		Branch	was removed. (see Figure 14).
Shoulder Screw		Support	7. Insert the 4 wire harness into one of the round
			holes in the rear of the valve cover shield and
	Valve		through the rectangular hole in the front of
Remove	Cover		shield (see Figure 14).
	Shield		8. Reconnect red wire to switch position 3.
Screw			Reconnect blue wire to switch position 1.
			Reconnect green and white wires.
			9. Install the switch plate on the valve cover shield
			with 2 #10 screws provided (see Figure 15).
			Reinstall the valve cover shield. Route power
			cord out of the cabinet by inserting it through the
			bushing on the outer casing (see Figure 14). Plug
		Bottom Louver	fan kit into 120-Volt grounded power supply and
Snap Bushings		Assembly	test operation. Note: When switch is in theAUTO
Figure 13 - Removing Valve Cover Shield			position, the fan will start after the heater has run
			for a few moments. The fan will continue to run for
Installing Blower Assembly			several moments after the heater has been turned
(Models CGCFTP and CGCFTN)			off. When switch is in the ON position, the fan
			will run until turned to OFF. Reinstall upper louver
CAUTION: Label all wires			assembly and hood if previously removed, (see
			Figure 12, page 12). Close lower louver door.
prior	to disconnection when
servicing controls. Wiring errors			Blower Bracket	Wire Harness
can cause improper and danger-			Assembly	Wiring Routing
ous operation.			Screw	Hole in Baffle

CAUTION: Verify proper op- eration after servicing.

Note: If you are using a mantel with your heater, use the following instructions. If your heater is built-in, see For Built-In Installation on page 14.

1.Install snap bushings found in hardware kit into both holes in rear of valve cover shield.

2.Make sure the wire harness is firmly connected to the terminals on the blower bracket assembly.

3.Note the wire locations on back of AUTO/ OFF/ON switch. The terminals on back of switch are numbered 1, 2 and 3. Carefully remove red wire from terminal 1 and blue wire from terminal 3. Black wire can remain on middle terminal 2 (see Figure 14).

4.Carefully disconnect green and white wires at their insulated connectors.

5.In top of the heater cabinet, locate the four mounting holes on the outer casing. Align these four holes with those on the blower bracket assembly. Attach blower bracket as- sembly to the outer casing with 4 #10 screws provided (see Figure 14).

Baffle

Switch Power

Cord

Red

Switch

Plate

Blue

Wire

Valve Cover Shield BoxCover Harness

Figure 14 - Installing Blower Bracket

Assembly

Valve

Cover

Shield

Switch Plate

Screw

Figure 15 - Installing Switch Plate to

Valve Cover Shield

111044-01J www.desatech.com 13