Desa VSGF33NRA, EFS33NRA Installing GAS Piping to Fireplace Location, Installation Items Needed

Page 13

INSTALLATION

Continued

Note: All vertical

 

Mantel Shelf

measurements

10"

 

 

 

 

are from top

8"

 

 

 

 

 

 

 

 

of fireplace

6"

 

 

 

 

 

 

 

 

opening to

 

 

 

 

2 1/2"

 

 

 

 

bottom of

 

 

 

 

 

 

 

 

 

mantel shelf.

 

 

 

 

 

Minimum Non-

 

 

 

 

 

Combustible

 

 

 

 

 

Material

13"

16"

19"

21"

 

 

 

 

 

 

 

 

 

Figure 16 - Minimum Mantel Clearances

for Built-In Installation

INSTALLING GAS PIPING TO FIREPLACE LOCATION

WARNING: This appliance requires a 1/2" NPT (National Pipe Thread) inlet connection to the pressure regulator.

WARNING: A qualified service person must connect fireplace to gas supply. Follow all local codes.

CAUTION:Neverconnectpro- pane/LP fireplace directly to the propane/LPsupply.Thisfireplace

Installation Items Needed

Before installing fireplace, make sure you have the items listed below.

external regulator for propane/LP unit only (supplied by installer)

piping (check local codes)

sealant (resistant to propane/LP gas)

equipment shutoff valve *

test gauge connection *

sediment trap (optional)

tee joint

pipe wrench

approved flexible gas line with gas connector (if allowed by local codes) (not provided)

*A CSA design-certified equipment shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. Purchase the optional CSA design-certified equipment shutoff valve from your dealer. See Accessories, page 34.

For propane/LP units, the installer must supply an external regulator. The external regulator will reduce incoming gas pressure. You must reduce incoming gas pressure to between 11 and 14 inches of water. If you do not reduce incoming gas pres- sure, heater regulator damage could occur. Install external regulator with the vent pointing down as shown in Figure 17. Pointing the vent down protects it from freezing rain or sleet.

CAUTION: Use only new, black iron or steel pipe. Inter- nally-tinned copper tubing may be used in certain areas. Check your local codes. Use pipe of 1/2" diameter or greater to allow proper gas volume to fireplace. If pipe is too small, undue loss of volume will occur.

requires an external regulator (notsupplied).Installtheexternal regulator between the fireplace and propane/LP supply.

WARNING: Never connect natural gas fireplace to private (non-utility) gas wells. This gas is commonly known as

External

Regulator

Vent

Pointing

Down

Propane/LP Supply Tank

wellhead gas.

Figure 17 - External Regulator with Vent

Pointing Down

107172-01K

www.desatech.com

13

Image 13
Contents What to do if YOU Smell GAS Table of Contents Safety Information Product Identification Log Base AssemblyLocal Codes Product FeaturesUnpacking Providing Adequate Ventilation AIR for Combustion VentilationDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Inside Building Ventilation AIRCheck GAS Type InstallationVentilation Air From Outdoors Electrical Hookup Installing HoodAssembling and Attaching Optional Brass Trim Conventional Fireplace Installation Installation ClearancesInstalling Cabinet Mantel BUILT-IN Fireplace InstallationRaise the mantel to an accept- able height Remove the mantel Installation Items Needed Installing GAS Piping to Fireplace LocationPropane/LP Connecting Fireplace to GAS SupplyNatural Gas Checking GAS ConnectionsTest Pressures In Excess Of 1/2 Psig 3.5 kPa Pressurize supply piping system by either Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPaInstalling Front Log Front Log Notch Grate Prongs Metal Grate Bars Operating Fireplace For Your Safety Read Before LightingLighting Instructions To Turn GAS OFF To Appliance Manual Lighting ProcedureOptional HAND-HELD Remote Operation Shutting Off HeaterManual Mode Auto Thermostatic ModeAuto Shutoff Feature ON/OFF Series Models Ghrcb and CghrcbInspecting Burners Key Pad Lock FeatureOptional Blower Operation Pilot Flame PatternFront Burner Flame Pattern Cleaning MaintenanceBurner Injector Holder and Pilot AIR Inlet Hole Specifications Wiring DiagramObserved Problem Possible Cause Remedy TroubleshootingSee Cleaning and Mainte Maintenance, Stalling Logs, Gas leak. See WarningService Hints Replacement PartsTechnical Service Parts Under WarrantyIllustrated Parts Breakdown Parts List Illustrated Parts Breakdown KEY Part Number Description QTY Accessories Receiver and Remote Control KIT Ghrcb Cghrcb Perimeter Trim AccessoryWALL-MOUNT ON/OFF Switch Corner Hearth BaseKeep this Warranty Warranty InformationLimited Warranty VENT-FREE GAS Fireplace