Desa VSGF33NRA Electrical Hookup, Installing Hood, Assembling and Attaching Optional Brass Trim

Page 9

INSTALLATION

Continued

WARNING: This appliance is equipped for (natural or pro- pane/LP) gas. Field conversion is not permitted.

ELECTRICAL HOOKUP

(Models GA3700 Series and GA3700T

Series Blower Accessories and GA3555

Internal Duplex Kit)

This fireplace accepts a blower assembly with an electrical cord. The electrical cord is five feet in length. You must locate fireplace within reach of a 120 volt grounded electrical outlet. If not, you must install an electrical outlet within reach of fireplace power cord. The GA3555 outlet acces- sory may be used for built-in applications with blower accessory installed.

INSTALLING HOOD

Install hood to rail already installed in fireplace as shown in Figure 5. Use 3 Phillips screws provided.

Rail

Hood

Screw

Figure 5 - Installing Hood

ASSEMBLING AND ATTACHING OPTIONAL BRASS TRIM

(Included with Mantel Accessory) IMPORTANT: If you are recessing the firebox in a wall, do not attach brass trim at this time. See Built-In Fireplace Installation, page 11.

Note: The instructions below show assembling and attaching brass trim to fireplace.

1.Remove packaging from three pieces of brass trim.

2.Locate four brass screws, two adjusting plates with set screws and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 6.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 6).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 6).

6.While firmly holding edges of brass trim to- gether, tighten both set screws on the adjusting plate with slotted screwdriver.

7.Repeat steps 1 through 6 for other side.

8.Tighten trim hanging screws (#10 x 6.25 shoulder) into holes in cabinets. Place the assembled trim onto fireplace cabinet. Align hanging notches on trim with hanging screws on side of fireplace (see Figure 7). Push trim firmly into place, sliding hanging notches over hanging screws.

 

 

Set Screws

Side Brass

Adjusting

Top

Plate

Brass

Trim

 

Trim

 

 

 

Shim

 

Slot

Slot

Mitered Edge

 

Figure 6 - Assembling Brass Trim

 

Trim

 

Hanging

 

Screws

 

Hanging

 

Notches

 

on Trim

Assembled

 

Brass Trim

 

Figure 7 - Attaching Brass Trim to

Fireplace (VSGF33NRA Shown)

107172-01K

www.desatech.com

9

Image 9
Contents What to do if YOU Smell GAS Table of Contents Safety Information Product Identification Log Base AssemblyProduct Features Local CodesUnpacking AIR for Combustion Ventilation Providing Adequate VentilationDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Inside Building Ventilation AIRInstallation Check GAS TypeVentilation Air From Outdoors Installing Hood Electrical HookupAssembling and Attaching Optional Brass Trim Conventional Fireplace Installation Installation ClearancesInstalling Cabinet Mantel BUILT-IN Fireplace InstallationRaise the mantel to an accept- able height Remove the mantel Installation Items Needed Installing GAS Piping to Fireplace LocationPropane/LP Connecting Fireplace to GAS SupplyChecking GAS Connections Natural GasTest Pressures In Excess Of 1/2 Psig 3.5 kPa Pressurize supply piping system by either Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPaInstalling Front Log Front Log Notch Grate Prongs Metal Grate Bars For Your Safety Read Before Lighting Operating FireplaceLighting Instructions To Turn GAS OFF To Appliance Manual Lighting ProcedureOptional HAND-HELD Remote Operation Shutting Off HeaterManual Mode Auto Thermostatic ModeAuto Shutoff Feature ON/OFF Series Models Ghrcb and CghrcbInspecting Burners Key Pad Lock FeatureOptional Blower Operation Pilot Flame PatternCleaning Maintenance Front Burner Flame PatternBurner Injector Holder and Pilot AIR Inlet Hole Specifications Wiring DiagramObserved Problem Possible Cause Remedy TroubleshootingSee Cleaning and Mainte Maintenance, Stalling Logs, Gas leak. See WarningService Hints Replacement PartsTechnical Service Parts Under WarrantyIllustrated Parts Breakdown Parts List Illustrated Parts Breakdown KEY Part Number Description QTY Accessories Receiver and Remote Control KIT Ghrcb Cghrcb Perimeter Trim AccessoryWALL-MOUNT ON/OFF Switch Corner Hearth BaseWarranty Information Keep this WarrantyLimited Warranty VENT-FREE GAS Fireplace