Desa VSGF33NRA, EFS33NRA installation manual Local Codes, Unpacking, Product Features

Page 5

LOCAL CODES

Install and use heater with care. Follow all local codes. In the absence of local codes, use the lat- est edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Note: Where listed vented decorative logs are required, thermostat operation is not permitted.

UNPACKING

CAUTION: Do not remove the dataplatesattachedtotheheater base assembly. The data plates contain important warranty and safety information.

1.With utility knife, cut the carton all the way around above the staples on the bottom tray. Lift the carton off the heater. Remove packing. Note: The hood is located in the packing on the right hand side of the heater front. Lift the heater off the bottom tray.

2.Locate two screws above top corners of the fireplace screen. Remove and discard these screws. Lift fireplace screen up and pull out to remove.

3.Remove protective packaging applied to logs, log base assembly and fireplace.

4.Remove fireplace hood from carton insert.

5.Check all items for any shipping damage. If damaged, promptly inform dealer where you bought fireplace.

PRODUCT FEATURES

OPERATION

This vent-free fireplace is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by both realistic flames and glowing embers. When used without the optional blower, the fireplace requires no electricity making it ideal for emergency backup heat.

SAFETY DEVICE

This fireplace has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/ pilot is a required feature for vent-free room heat- ers. The ODS/pilot system shuts off the fireplace if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This fireplace has a piezo ignitor. This system requires no matches, batteries or other sources to light fireplace.

OPTIONAL REMOTE CONTROL ACCESSORY

There are four optional remote controls (not included) that can be purchased separately for this log heater:

wall switch

wall thermostat

hand-held ON/OFF remote

hand-held thermostat remote See Accessories, page 34.

OPTIONAL BLOWER ASSEMBLY ACCESSORY

This fireplace accepts an optional blower assembly (not included). The GA3700TA Series blower operates thermostatically and features a variable speed control. The GA3700 Series operates manu- ally and also features a variable speed control. The blower circulates heated air from the fireplace into the room. Use of blower is optional. See Acces- sories, page 34.

107172-01K

www.desatech.com

5

Image 5
Contents What to do if YOU Smell GAS Table of Contents Safety Information Product Identification Log Base AssemblyUnpacking Product FeaturesLocal Codes Determining FRESH-AIR Flow for Heater Location AIR for Combustion VentilationProviding Adequate Ventilation Ventilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors InstallationCheck GAS Type Assembling and Attaching Optional Brass Trim Installing HoodElectrical Hookup Conventional Fireplace Installation Installation ClearancesInstalling Cabinet Mantel BUILT-IN Fireplace InstallationRaise the mantel to an accept- able height Remove the mantel Installation Items Needed Installing GAS Piping to Fireplace LocationPropane/LP Connecting Fireplace to GAS SupplyTest Pressures In Excess Of 1/2 Psig 3.5 kPa Checking GAS ConnectionsNatural Gas Pressurize supply piping system by either Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPaInstalling Front Log Front Log Notch Grate Prongs Metal Grate Bars Lighting Instructions For Your Safety Read Before LightingOperating Fireplace To Turn GAS OFF To Appliance Manual Lighting ProcedureOptional HAND-HELD Remote Operation Shutting Off HeaterManual Mode Auto Thermostatic ModeAuto Shutoff Feature ON/OFF Series Models Ghrcb and CghrcbInspecting Burners Key Pad Lock FeatureOptional Blower Operation Pilot Flame PatternBurner Injector Holder and Pilot AIR Inlet Hole Cleaning MaintenanceFront Burner Flame Pattern Specifications Wiring DiagramObserved Problem Possible Cause Remedy TroubleshootingSee Cleaning and Mainte Maintenance, Stalling Logs, Gas leak. See WarningService Hints Replacement PartsTechnical Service Parts Under WarrantyIllustrated Parts Breakdown Parts List Illustrated Parts Breakdown KEY Part Number Description QTY Accessories Receiver and Remote Control KIT Ghrcb Cghrcb Perimeter Trim AccessoryWALL-MOUNT ON/OFF Switch Corner Hearth BaseLimited Warranty VENT-FREE GAS Fireplace Warranty InformationKeep this Warranty