Desa CSDPBN, CSDBN installation manual Installing LOGS, Lava Rock and Glowing Embers

24

STOVE AND BURNER SYSTEM INSTALLATION

Installing Optional Wireless Hand-Held Remote Control Accessories - GHRCB and GHRCTB Series (Cont.) Installing Logs, Lava Rock and Glowing Embers

STOVE AND BURNER SYSTEM INSTALLATION

Continued

4.Place receiver into valve bracket and align holes (see Figure 52).

5.Use push-in fasteners included with receiver to secure to bracket.

6.Connect the wires from the receiver to the valve at TH and THTP (see Figure 48, page 22).

INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this burner system may result in property damage or personal injury.

TPTH TP TH

Figure 52 - Installing Remote Receiver

Installing 9-Volt Alkaline Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit

2.Attach terminal wires to a 9-volt battery (not included). Place battery into the battery housing.

3.Replace battery cover onto remote control unit.

Battery Remote

TerminalCover Control Unit

Wires

9-Volt Battery

Battery

Housing

Figure 53 - Installing Battery in Hand-Held Remote Control Unit (GHRCB Series)

9-Volt	Terminal	Remote
	Wires
Battery
		Control
		Unit

You must remove glass door and front panel to install logs, lava rock, and ember material. See Removing/ Replacing Glass Door, page 6.

It is very important to install these logs exactly as instructed in Figures 55 through 58. Do not modify logs. Only use logs supplied with freestanding burner system. Do not use if any log(s) are broken (see Replacement Parts, page 33).

1.Remove glass door. See Removing/Replacing Glass Door, page 6.

2.Place log #1 (back log) on top of grate. Make sure the notches in the bottom of the log fit over the grate (see Figure 55).

2.Rest log #2 (large front log) on the pins on the front part of the grate (see Figure 56).

3.Place log #3 (crossover log) onto the rear and front logs. Make sure it is seated properly into the notch on the front log and over the raised triangular portion of the rear log as shown in Figure 57, page 25.

4.Place log #4 (small log) onto the front left part of the grate making sure the notches fits over the prong of the grate. See Figure 58, page 25.

1 2

	Battery
Battery Housing	Cover
Figure 54 - Installing Battery in Hand-Held Remote Control Unit		Figure 55 - Installing Log	Figure 56 - Installing Log No. 2

(GHRCTB Series) No. 1

For..com

111739-01A