Vermont Casting DV580, DV360 manual Clearance to Combustibles, Mantels, Hearth

DV360/580 Series Direct Vent Gas Fireplace

Clearance to Combustibles

Top of unit to ceiling	36” (914 mm)
Front of unit to combustibles	36” (914 mm)
Appliance
Top of standoff	0” (0 mm)
Bottom	0” (0 mm)
Side	0” (0 mm)
Back	0” (0 mm)
Venting
Concentric sections of DV Vent	1” (25 mm)
Nonconcentric sections of DV Vent
Sides and bottom	1” (25 mm)
Top	2” (51 mm)

Mantels

The height that a combustible mantel is fitted above the fireplace is dependent on the depth of the mantel. This also applies to the distance between the mantel leg (if fitted) and the fireplace.

For the correct mounting height and widths, refer to Figures 4a, 4b and the Mantel Chart below.

The distances and reference points are not affected by the fitting of a bay window front trim kit.

Noncombustible mantels and legs may be installed at any height and width around the appliance. When using paint or lacquer, it must be heat resistant to prevent discoloration.

V

W

X

Y

Z

							Maintain minimum
							3/4” (19 mm) clear-
	A B	C D	E				ance to combustibles
				Fireplace
					Louvre Assembly
					top
					Top of Combustion
					Chamber
Bottom of Door Trim								CFM146
			Mantel Chart
	Mantel Shelf						Mantel from Top
Ref.	or Breast Plate			Ref.		of Comb. Chamber
		Depth
V	10”	(254 mm)		A			19”	(483 mm)
W	8”	(203 mm)		B			17”	(432 mm)
X	6”	(152 mm)		C			15”	(381 mm)
Y	4”	(101 mm)		D			13”	(330 mm)
Z	2”	(51 mm)		E			11”	(279 mm)
Fig. 4a	Combustible mantel minimum installation.

Black					J I H	G
Surround
Face		Mantel				F
CFM164a		Leg
Side of					MLK
Combustion Chamber				N
				O
						CFM170
		Mantel		Mantel Leg from Side
Ref.	Leg Depth		Ref.	of Comb. Opening
F	10”	(254 mm)	K	11¹⁄₂”	(292 mm)
G	8”	(203 mm)	L	9¹⁄₂”	(241 mm)
H	6”	(152 mm)	M	7¹⁄₂”	(191 mm)
I	4”	(101 mm)	N	5¹⁄₂”	(140 mm)
J	2”	(51 mm)	O	3¹⁄₂”	(89 mm)
Fig. 4b	Combustible mantel leg minimum installation.

Hearth

A hearth is not mandatory, but is recommended for aesthetic purposes. We recommend a noncombustible hearth which projects out 12” (305 mm) or more from the front of the fireplace.

Cold climate installation recommendation:

When installing this unit against a non-in- sulated exterior wall or chase, it is manda- tory that the outer walls be insulated to conform to applicable insulation codes.

6 20010667