Empire Comfort Systems VF24FP3-1, VF24FP2-1 installation instructions 20248-2-0806

Page 23

Figure 3

23.Position blower shield side beneath left flange on burner assembly.Align clearance hole on left flange of burner assembly with screw hole on blower shield side. Attach burner assembly to blower shield side with one (1) 10 x 1/2" screw. (See Figure 3 for not installed or Figure 4 for installed)

24.Remove 8 x 1/4" screw located on left, front of valve cover on

Figure 4

burner assembly. Insert blower shield front adjacent to blower motor and blower shield side. Align clearance hole on blower shield front with left, front screw hole on valve cover. Attach blower shield front to valve cover with 10 x 1/2" screw. (See Figure 3 for not installed or Figure 4 for installed)

25.For fireplace that is not installed, replace burner assembly into interior of fireplace.

26.Place inner casing in front of outer casing.

27.Insert inner casing assembly into outer casing.

20248-2-0806

Page 23

Image 23
Contents Installation Instructions Table of Contents Death Important Safety InformationDo not Tamper with Pilot Light Safety Carbon Monoxide Poisoning MAY Lead toLP-GAS Warning Odor Safety Information for Users of LP-GASIntroduction Water Vapor a BY-PRODUCT of Unvented Room Heaters SpecificationsVentilation Air From Outdoors Ventilation Air From Inside BuildingOutdoors Ventilation AIRRecommended Gas Pipe Diameter GAS SupplyCombustible Material ClearancesInstalling Fireplace in Mantel Installation of Fireplace Into MantelInstallation of Trim Rough Opening for Installing in Corner BUILT-IN Fireplace InstallationBuilt-In Fireplace Installation Rough Opening for Installing in WallOperation INSTRUCTIONS/FLAME Appearance LOG PlacementPlacement of Glowing Embers Rock Wool Replacement Loose Material glowing embers Part NumberWhat to do if YOU Smell GAS VF24FP3-1 Lighting InstructionsLighting Instructions VF24FP2-1 Lighting InstructionsVF24FP2-1 Pilot Pilot Flame CharacteristicsVF24FP3-1 Pilot VF24FP3-1 Main Burner Operation Bedroom Installation VF24FP2-1 OnlyMain Burner and Thermostat Operation VF24FP2-1Remote Receiver Check 750 Millivolt System OperationAppliance shuts off during use. Pilot stays on Gas odor even when control knob is in OFF positionHeater produces a whistling noise when main burner is lit Appliance produces unwanted odorsIndex Part Description Number Parts ListHOW to Order Repair Parts Parts View Parts List for EHL-24-1, Brick Liner KIT Optional Brick Liner Installation InstructionsInstalling Optional Brick Liner EHL-24-1 Installing Optional Blower VFS-BK Optional Blower Installation Instructions20248-2-0806 Optional Blower Installation Instructions Oiling Blower Motor WiringVFS-BK Parts List VPF24SS Stainless Steel Parts List and Parts View for Optional Trim KitsService Notes