Empire Comfort Systems VF24FP2-1, VF24FP3-1 Optional Blower Installation Instructions

Page 24

OPTIONAL BLOWER INSTALLATION INSTRUCTIONS (cont.)

Figure 5

28.Place fan control bracket with wires on top of inner casing. Remove right, front 10 x 1/2" screw from top of inner casing. Attach fan control bracket to top of inner casing with 10 x 1/2" screw. Refer to Figure 5 for correct position of fan control bracket for 10,000 Btu input or 20,000 Btu input.

29.Attach inner casing to outer casing with six (6) 10 x 1/2" screws from Step 6. Tighten two (2) 10 x 1/2" screws at interior, top of inner casing that were loosened in Step 6.

30.Attach burner assembly to inner bottom with three (3) 10 x 1/2" screws from Step 5.

Figure 6

31.Attach rear log support to inner casing with three (3) 10 x 1/2" screws from Step 4.

32.Place and align blower diverter on top of inner casing. Attach deflector to top of inner casing with two (2) 10 x 1/2" screws. (See Figure 6)

33.Attach top louver with two (2) 8 x 1/2" Phillips screws from Step 3.

34.Attach screen front.

35.Raise bottom louver.

36.Installation of optional blower assembly is completed.

Page 24

20248-2-0806

Image 24
Contents Installation Instructions Table of Contents Important Safety Information Do not Tamper with Pilot Light SafetyCarbon Monoxide Poisoning MAY Lead to DeathSafety Information for Users of LP-GAS LP-GAS Warning OdorIntroduction Specifications Water Vapor a BY-PRODUCT of Unvented Room HeatersVentilation Air From Inside Building OutdoorsVentilation AIR Ventilation Air From OutdoorsGAS Supply Recommended Gas Pipe DiameterClearances Combustible MaterialInstallation of Fireplace Into Mantel Installation of TrimInstalling Fireplace in Mantel BUILT-IN Fireplace Installation Built-In Fireplace InstallationRough Opening for Installing in Wall Rough Opening for Installing in CornerLOG Placement Placement of Glowing Embers Rock WoolReplacement Loose Material glowing embers Part Number Operation INSTRUCTIONS/FLAME AppearanceVF24FP3-1 Lighting Instructions What to do if YOU Smell GASVF24FP2-1 Lighting Instructions Lighting InstructionsPilot Flame Characteristics VF24FP3-1 PilotVF24FP2-1 Pilot Bedroom Installation VF24FP2-1 Only Main Burner and Thermostat OperationVF24FP2-1 VF24FP3-1 Main Burner OperationCheck 750 Millivolt System Operation Remote ReceiverGas odor even when control knob is in OFF position Heater produces a whistling noise when main burner is litAppliance produces unwanted odors Appliance shuts off during use. Pilot stays onParts List HOW to Order Repair PartsIndex Part Description Number Parts View Optional Brick Liner Installation Instructions Installing Optional Brick Liner EHL-24-1Parts List for EHL-24-1, Brick Liner KIT Optional Blower Installation Instructions Installing Optional Blower VFS-BK20248-2-0806 Optional Blower Installation Instructions Wiring VFS-BK Parts ListOiling Blower Motor Parts List and Parts View for Optional Trim Kits VPF24SS Stainless SteelService Notes