Accessory
Installation
Continued
7. | Remove blower/heater assembly with 4 |
| screws from packaging. Blower is pre- |
| wired for convenience. |
8. | Align blower assembly over hole pattern on |
| blower mount and attach with 4 pan head |
| screws provided (see Figures 22 and 23). |
9. | With discharge pointing towards you, guide |
| assembled blower mount into fireplace |
| and center rear mounting flanges between |
| standoff brackets at rear of the fireplace. |
10. | Lift blower mount up and position 4 locking |
| tabs through notched openings in firebox |
| top. Slide assembly forward until locked |
| into position. |
11. | Remove control panel knockout plug lo- |
| cated in heater switch position by pressing |
| locking tabs and pushing plug out through |
| front of panel (see Figure 24). |
14.Connect black heater wire to terminal marked
Heater/
Blower
Assembly
Harness
Strap
Blower
Mount
Mounting
Screws
Figure 22 - Mounting Heater/Blower
12. | Firmly insert red power switch into open |
| mount location with “ON” (I) indicator |
| positioned on top. |
13. | Connect white heater wire to neutral |
| connection marked 'B' or 'A' on terminal |
| block. See partial wiring diagram, Figure |
| 25, page 12. |
Notches for
Control Cover Blower Mount
Notch (1 of 4)
Control
Panel Blower
Mount
Heater/
Blower
Assembly
Mounting
Screws
Blower 
Mount
Screws
Control | Hex | |
Screws | ||
Cover | ||
| ||
Screws | Control | |
| Cover |
Figure 21 - Disassembling Blower Mount
Figure 23 - Mounting Alternate Heater/
Blower
Knockout Plug
-Remove to Install Power
Switch
Power
Switch
Figure 24 - Installing Heater Power Switch
www.desatech.com | 11 |