Features Operation, Lamps and lava Rock

INSTALLATION

Continued

Motor

Mount

Foam

Shipping

Brace

Figure 11 - Removing Shipping Brace

Lamps and lava Rock

Before operating fireplace, lamp bulbs must be inspected and lava rock may be added if desired.

1.Lift log bed off hearth base to gain access to lamp fixtures (log bed is attached with contact magnets).

2.Turn on power to light circuit and check that all bulbs are operating. Bulb place- ment front left to right are red, yellow and orange (see Figure 12).

Note: If bulbs need replacing, see Replac- ing Light Bulbs, page 15. Be careful not to tear or damage reflective strips. If they have come loose, ends can be easily reattached or replaced at support brackets. See Replacing Reflective Ribbons, page 19.

3.Center log bed over opening between viewing panel screen and grate.

4.Cover remaining hearth area with 1/4" of lava rock (provided), if desired.

Viewing Panel

Screen

Red

Yellow

Orange

Grate

Log Bed

Figure 12 - Bulb Placement

Features and

Operation

This electronic fireplace series features a random flame effect, and a realistic log bed with glistening embers that can be adjusted for flame speed and light intensity. VE36/32LH models have a circulating heater, rated at 1100 Watts. Models VE36/32LB and VE36/ 32LBH include a hand detailed, textured, red-brick lining.

Access controls by pulling two handle tabs of upper louver until panel releases from magnetic catches and swings down to open position (see Figure 13).

Figure 14, page 8, shows control layout for heater equipped models with main power switch to flame controls and heater power switch (when equipped) to heating unit. This allows independent and efficient operation of both features.

Once main power is turned on, flame speed and brightness may be turned on and adjusted independently.

Figure 13 - Accessing Controls

115121-01Bwww.desatech.com