FEATURES AND OPERATION
Continued
ON/OFF | Flame Speed | Heater Switch | |
Switch | |||
|
|
MAIN | HI- OFF LOW | HI- OFF LOW | HEATER |
POWER |
| ||
| FLAME SPEED | FLAME BRIGHTNESS |
|
Flame Brightness
Figure 14 - Control Panel
Accessory
Installation
OPTIONAL GLASS DOORS
Models VE36L and VE32L will accept bifold glass doors that are fully operable or a fixed panel door that limits access to fireplace, (see Accessories, page 23).
Installing Bifold Glass Doors
Follow these steps to install left and right operable panels:
1.With handle down, completely fold panel on its hinges.
2.With handle facing center of firebox open- ing insert lower pivot pin on door panel into hole in bottom outer edge of firebox opening (see Figure 15).
3.Keep folded door tilted and slide upper two pins into guide track below upper facial edge of firebox opening.
4.Tilt glass assembly fully vertical until outer pivot pin snaps into mounting hole in up- per spring clip.
5.Once top and bottom pins are secured, unfold door into closed position.
6.Repeat steps 1 through 5 for opposite door assembly.
7.To adjust doors, slide partially open. Using a Phillips screwdriver, loosen hold- down screws on spring clips (see Figure 16).
8.Close both doors until evenly joined at middle and note gap as measured to outer edges of front face.
9.Reopen each door one at a time and retighten the
10.Repeat process until both doors are even- ly joined, spaced and working freely.
Spring Clip
Depress Spring
Clip to Release
Pivot Pin
Fold Bifold Door
After Releasing
Spring Clip to
Slide Door Out of
Upper Track
Remove Pivot Pin
From Bottom Face
While Sliding Door
Out of Upper Track
Pivot Pin
Figure 15 - Installing/Removing Glass
Doors
Side Front |
|
Face | Spring Clip |
Partially
Opened
Door
Figure 16 - Adjust Glass Door
www.desatech.com115121-01B