Avalon Stoves Indoor Fireplace manual Adjusting the Door Hinge and Latch, Hinge Adjustment

Page 33

Maintenance3 3

Yearly Maintenance (or every ton) - Continued

Adjusting the Door Hinge and Latch

•The door hinge and door latches may be adjusted to pull the door closer to the body. The illustration below details how to adjust these components. NOTE: Make sure to read the section "Door Alignment" on the previous page before adjusting the door.

Latch Adjustment

Door Hinge Bracket

Hinge Adjustment

(1) With the door closed, loosen the two bolts going through the door hinge bracket.

(2)Loosen the four nuts used to move the hinge adjusting plate.

Tighten or loosen these nuts to adjust the door hinge bracket. Adjust the upper and lower nuts equally to insure the door remains level. Tighten the four nuts.

Loosen the lock nut and twist the pawl (clockwise to tighten, counter-clockwise to loosen). Tighten the lock nut to secure in place.

Bracket (attached to side of

heater)

Door

Pawl

Lock Nut

Dimple (used to monitor hinge bracket position)

Door

Hinge Adjusting Plate

(3)Tighten the two bolts loosened in step 1.

Travis Industries

4 0 5 0 5 2 5

1 0 0 - 0 1 1 4 4

Image 33

Contents

Astoria Bay Pellet Insert 2Introduction Introduction Important InformationTravis Industries 5 0 5 2 0 0 1 1 4 Table of Contents Safety Precautions Mobile Home 6Specifications Installation7 Hopper Extension Set-up 8InstallationRe-install the hopper walls following the directions below Installation90Installation Venting the Pellet Stove Installation12Installation Mobile Home RequirementsOutside Air used for combustion Restrictor Adjustment Baffle InstallationSurround Panel & Circuit Board Installation 4InstallationHint Installation into a Masonry FireplaceInstallation into a Factory Built Metal Fireplace 6InstallationOperation1 Safety NoticeLocation of Controls Starting the Heater for the First Time8Operation Loading PelletsTwo Modes of Operation To Adjust the Heat Manual ModeTo Start To Shut DownAuto Mode To Adjust Room Temperature or Start the Stove0Operation Operation2 Adjusting the Fan Speed2Operation Maintenance Required LightStart-Up Sequence Auger on LightPower Outages Using a Pellet/Corn Mix with This HeaterManual Auger Button Daily Maintenance whenever using the heater 4MaintenanceInspect the Burn Make Sure Pellets are Not Piling UpMaintenance2 Cleaning the FirepotCheck Firepot for Clinkers Opening The Door 6MaintenanceClean the Hopper Weekly Maintenance or every 5 bags of pelletsClean the Heat Exchange Tubes Cleaning the Optional Plated Surfaces8Maintenance Clean the GlassCheck Baffles, Ashbox, Ashpan, Dispose Ash If Necessary Sweep Ash Into Ashpan Remove the ashbox prior to conducting the service belowYearly Maintenance or every ton 0MaintenanceClean the Vent make sure the heater and vent is cool Maintenance32Maintenance Door SealDoor Alignment Hinge Adjustment Adjusting the Door Hinge and LatchCheck for Air Leaks Around the Door, Glass, and Ashpan Replacement PartsCovection Fan Normal Operating SoundsSerial No Safety LabelYears 1 & 2 Coverage Parts & Labor Limited 7 Year WarrantyThermostat 8Optional EquipmentZC Kit 9 9 2 0 0 1 4 Optional Equipment0Index