Avalon Stoves Indoor Fireplace manual 6Specifications

Page 6

6Specifications

Heating Specifications:

Approximate Maximum Heating Capacity (in square feet)*

800 to 2,250

Burn Rate (Pounds per Hour)**

1.7 to 5.5

Maximum Burn Time on Low Burn**

28 to 52 Hours

Hopper Capacity (based upon hopper extension position)

48 to 89 Pounds

*Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside temperature. It is also affected by the fuel size, quality, and moisture level.

**Small pellets will increase or decrease the stated burn rates and burn times. Differences of plus or minus 20% depending on fuel quality may occur.

Dimensions:

Center of 4” diameter Flue is 16-7/8” above the baseplate and 7-1/2” left of center

32”

26-1/2”

25-1/2” (allow 36” width for control board installation)

25-3/4” to 20”

See “Hopper Extension Set-up” for details.

 

45”

 

13-1/4” (allow 14” depth in the Fireplace)

 

 

 

 

 

 

Fireplace Opening

12"

 

 

 

Door Opening

Electrical Specifications:

 

Electrical Rating

115 Volts, 3.6 Amps, 60 Hz

Watts During Start-Up Sequence

400 (approximately)

Watts During Operation

180 (approximately)

Fuel:

•This heater is designed and approved for pelletized wood fuel or a mixture up to 50% corn, 50% pellets. See page 23 for details on using a corn pellet mix.

EPA Compliance:

This heater is EPA exempt from Phase II requirements, but has been tested for emissions using EPA test methods by OMNI Test Labs.

Travis Industries

4 0 5 0 5 2 5

1 0 0 - 0 1 1 4 4

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Astoria Bay Pellet Insert 2Introduction Introduction Important InformationTravis Industries 5 0 5 2 0 0 1 1 4 Table of Contents Safety Precautions Mobile Home 6Specifications Installation7 8Installation Hopper Extension Set-upInstallation9 Re-install the hopper walls following the directions below0Installation Installation1 Venting the Pellet Stove2Installation Mobile Home RequirementsOutside Air used for combustion Baffle Installation Restrictor Adjustment4Installation Surround Panel & Circuit Board InstallationInstallation into a Masonry Fireplace Hint6Installation Installation into a Factory Built Metal FireplaceLocation of Controls Safety NoticeOperation1 Starting the Heater for the First Time8Operation Loading PelletsTwo Modes of Operation To Start Manual ModeTo Adjust the Heat To Shut DownAuto Mode To Adjust Room Temperature or Start the Stove0Operation Adjusting the Fan Speed Operation2Start-Up Sequence Maintenance Required Light2Operation Auger on LightPower Outages Using a Pellet/Corn Mix with This HeaterManual Auger Button Inspect the Burn 4MaintenanceDaily Maintenance whenever using the heater Make Sure Pellets are Not Piling UpMaintenance2 Cleaning the FirepotCheck Firepot for Clinkers 6Maintenance Opening The DoorClean the Heat Exchange Tubes Weekly Maintenance or every 5 bags of pelletsClean the Hopper Cleaning the Optional Plated Surfaces8Maintenance Clean the GlassCheck Baffles, Ashbox, Ashpan, Dispose Ash If Necessary Remove the ashbox prior to conducting the service below Sweep Ash Into Ashpan0Maintenance Yearly Maintenance or every tonMaintenance3 Clean the Vent make sure the heater and vent is cool2Maintenance Door SealDoor Alignment Adjusting the Door Hinge and Latch Hinge AdjustmentReplacement Parts Check for Air Leaks Around the Door, Glass, and AshpanNormal Operating Sounds Covection FanSafety Label Serial NoLimited 7 Year Warranty Years 1 & 2 Coverage Parts & Labor8Optional Equipment ThermostatOptional Equipment ZC Kit 9 9 2 0 0 1 40Index

Indoor Fireplace specifications

The Avalon Stoves Indoor Fireplace is a remarkable addition to any home, offering the perfect blend of aesthetics, functionality, and efficiency. Designed with a focus on both beauty and performance, this fireplace redefines the indoor heating experience while enhancing the ambiance of any living space.

One of the standout features of the Avalon Stoves Indoor Fireplace is its clean and contemporary design. Available in various styles and finishes, it fits seamlessly into diverse interior décors, from modern to rustic. The large glass viewing panel provides an expansive view of the flames, allowing users to enjoy the mesmerizing fire while adding warmth to the room.

Energy efficiency is at the heart of Avalon’s design philosophy. The fireplace is equipped with advanced combustion technology that maximizes burn efficiency, ensuring that more heat is extracted from the fuel. This leads to reduced fuel consumption and lower heating costs, making it an environmentally friendly choice. Some models feature a secondary combustion system, which allows the fireplace to burn cleaner, producing fewer emissions and adhering to stringent environmental regulations.

Another significant characteristic of the Avalon Stoves Indoor Fireplace is its versatility in fuel options. Homeowners can choose from traditional wood-burning models or the more contemporary propane and natural gas variants. This flexibility allows users to select the most suitable fuel source for their needs and preferences. The easy-to-use ignition systems further enhance the convenience of starting and maintaining the fire.

Safety features are paramount in the design of Avalon fireplaces. With options for air wash systems that keep the glass clean and cooling features to prevent overheating, users can enjoy a cozy fire with peace of mind. The construction materials are selected for their durability and heat resistance, ensuring that the fireplace stands the test of time.

In summary, the Avalon Stoves Indoor Fireplace combines an elegant design with advanced technology and safety features. Its energy efficiency, versatility in fuel options, and stylish appearance make it a top choice for those looking to add warmth and charm to their home. Whether for heating or simply enjoying the beauty of fire, Avalon offers a fireplace solution that meets modern lifestyles while providing a timeless appeal.
Top Page Image Contents