MartinLogan 33ISDG operating instructions Installing Right Front Log #6, Placing Rock Wool

Page 25

LOG PLACEMENT

6.Place right front log (#6) on two pins on the right front of grate. See Figure 25.

Right Front Log (#6)

Right Base Log

Pins

Figure 25 - Installing Right Front Log (#6)

PLACING ROCK WOOL

After installing logs, place TPB-RW (Rock Wool) in dime-size pieces evenly across the burner surface in between the logs. Do not add additional Rock Wool. See Figure 26

Wash hands after placing Rock Wool. Itching may occur.

.

•Use only TPB-RW provided with log set.

•Do not add additional rock wool.

Extrusions

Dime-Size

Rock Wool

Figure 26 - Placing Rock Wool

23D8036

25

Image 25

Contents What to do if YOU Smell GAS Model 33ISDGRead and Save These Instructions Contents Installer Important Safety InformationOwner This product must be installed by a Operation Product FeaturesNatural GAS Product Features and SpecificationsPROPANE/LPG Getting Started What YOU will Need for InstallationMake Sure YOU have Received ALL Parts Installing Canopy General Installation InformationRemoving Screen Adequate Combustion and Ventilation AIR CodesBTU/Hr = 15 1/ 2 x 12 x 1000 = 29760 BTU/Hr Clearances and Height Requirements Before Installing the Fireplace InsertClearances and Height Requirements Minimum Clearance above Combustible Flooring Fireplace Framing Outer Wall InstallationSecuring Heater to Floor Removing Grate and Base AssemblyConnecting the GAS Access Holes Millivolt Control Figure Checking GAS PressureConnecting Optional Wall Switch or Thermostat Electrical Wiring MILLI-VOLTThat does not Require 110 VAC to Operate Complete Millivolt System Check Checking System OperationWhite Electrical Wiring FANInstalling Blazing OAK Logs on Burner LOG PlacementInstalling Left Base Log #3 Installing Left Top Log #5 Placing Rock Wool Installing Right Front Log #6Checking the Pilot Flame Flame AppearanceThermostat and MILLI-VOLT Control Operating Instructions Checking the Burner FlameOperating Instructions For Your Safety Read Before LightingMILLI-VOLT/THERMOSTAT Control Lighting Instructions Operating Instructions and Blower Operation Match Lighting InstructionsCleaning and Servicing Observed Problem Possible Cause Remedy TroubleshootingODS/pilot lights, but flame Illustrated Parts Breakdown DIS33N/P Replacement Parts ListIllustrated Parts Breakdown Replacement Parts are Available Through Your Retailer BOCL18 Blazing OAK Logs23D8036 Basic Warranty Five Year Warranty