MartinLogan 33ISDG operating instructions Electrical Wiring FAN, White

Page 21

WARNING

ELECTRICAL WIRING (FAN)

This ﬁreplace has a three-prong, grounded electrical plug. This plug helps protect you against electrical shock. Only connect plug to a properly grounded, three-prong receptacle. Do not cut or remove the grounded prong from this plug.

WARNING	Never attempt to service heater while
	Never attempt to service heater while
	it is plugged in, operating, or hot.
	Burns and/or electrical shock could
	result.

IMPORTANT: Always check local building codes. The installation must comply with local regulations as well as the national electric codes.

			Fan Switch	Thermostat
				Control
	110/115	OFF		Blower
				Blower
				Motor
	V.A.C.	Black	ON	Motor
	V.A.C.	Black	ON	Black
		White		Black
		Green

Figure 22 - ISD Wiring Diagram

If any of the original wire as supplied with the fireplace must be replaced, contact dealer for proper replacement wiring har- ness. (see parts list for part number). 120 volts, 60Hz, 1 amps.

Electrical power cord (plug) can be routed to exit the 33ISD on either the left side or the right side. Remove cord protec- tor from side of unit, route power cord through hole opposite side. Reinstall cord protector.

23D8036

21

Image 21

Contents Model 33ISDG What to do if YOU Smell GASRead and Save These Instructions Contents Important Safety Information InstallerOwner This product must be installed by a Operation Product FeaturesProduct Features and Specifications Natural GASPROPANE/LPG What YOU will Need for Installation Getting StartedMake Sure YOU have Received ALL Parts General Installation Information Installing CanopyRemoving Screen Adequate Combustion and Ventilation AIR CodesBTU/Hr = 15 1/ 2 x 12 x 1000 = 29760 BTU/Hr Clearances and Height Requirements Before Installing the Fireplace InsertClearances and Height Requirements Minimum Clearance above Combustible Flooring Fireplace Framing Outer Wall InstallationSecuring Heater to Floor Removing Grate and Base AssemblyConnecting the GAS Access Holes Millivolt Control Figure Checking GAS PressureElectrical Wiring MILLI-VOLT Connecting Optional Wall Switch or ThermostatThat does not Require 110 VAC to Operate Complete Millivolt System Check Checking System OperationWhite Electrical Wiring FANInstalling Blazing OAK Logs on Burner LOG PlacementInstalling Left Base Log #3 Installing Left Top Log #5 Placing Rock Wool Installing Right Front Log #6Flame Appearance Checking the Pilot FlameThermostat and MILLI-VOLT Control Operating Instructions Checking the Burner FlameOperating Instructions For Your Safety Read Before LightingMILLI-VOLT/THERMOSTAT Control Lighting Instructions Operating Instructions and Blower Operation Match Lighting InstructionsCleaning and Servicing Observed Problem Possible Cause Remedy TroubleshootingODS/pilot lights, but flame Illustrated Parts Breakdown DIS33N/P Replacement Parts ListIllustrated Parts Breakdown Replacement Parts are Available Through Your Retailer BOCL18 Blazing OAK Logs23D8036 Basic Warranty Five Year Warranty