MartinLogan 33ISDG operating instructions Checking the Burner Flame, Operating Instructions

Page 27

CHECKING THE BURNER FLAME

In normal operation at full rate after 15 minutes, the following flame appearances should be observed:

Glowing Embers

Figure 33 - Correct Appearance of Rear Flames

Burner will have a random pattern of yellow flames as shown in Figure 33. There should be glowing embers on the front burner. Note: The ﬂames and embers will be an opaque orange color during the burn off time.

OPERATING INSTRUCTIONS

Avoid any drafts that alter burner ﬂame patterns. Do not allow fans to blow directly into the fireplace. Do not place a blower inside the burn area of the firebox. Ceiling fans may create drafts that alter flame patterns. Sooting and improper burning will result.

During manufacturing, fabricating and shipping, various components of this appliance are treated with certain oils, films or bonding agents. These chemicals are not harmful, but may produce annoying smoke and smells as they are burned off during the initial operation of the appliance, possibly causing headaches or eye or lung irritation. This is a normal and temporary occurrence.

The initial break-in operation should last six hours with the burner at the highest setting. Provide maximum ventilation by opening windows or doors to allow odors to dissipate. Any odors remaining after this initial break-in will be slight and will disappear with continued use.

This appliance must not be used with glass doors in the closed position. This can lead to pilot outages and severe sooting outside the fireplace.

23D8036

27

Image 27

Contents Model 33ISDG What to do if YOU Smell GASRead and Save These Instructions Contents Important Safety Information InstallerOwner This product must be installed by a Operation Product FeaturesProduct Features and Specifications Natural GASPROPANE/LPG What YOU will Need for Installation Getting StartedMake Sure YOU have Received ALL Parts General Installation Information Installing CanopyRemoving Screen Adequate Combustion and Ventilation AIR CodesBTU/Hr = 15 1/ 2 x 12 x 1000 = 29760 BTU/Hr Clearances and Height Requirements Before Installing the Fireplace InsertClearances and Height Requirements Minimum Clearance above Combustible Flooring Fireplace Framing Outer Wall InstallationSecuring Heater to Floor Removing Grate and Base AssemblyConnecting the GAS Access Holes Millivolt Control Figure Checking GAS PressureElectrical Wiring MILLI-VOLT Connecting Optional Wall Switch or ThermostatThat does not Require 110 VAC to Operate Complete Millivolt System Check Checking System OperationWhite Electrical Wiring FANInstalling Blazing OAK Logs on Burner LOG PlacementInstalling Left Base Log #3 Installing Left Top Log #5 Placing Rock Wool Installing Right Front Log #6Flame Appearance Checking the Pilot FlameThermostat and MILLI-VOLT Control Operating Instructions Checking the Burner FlameOperating Instructions For Your Safety Read Before LightingMILLI-VOLT/THERMOSTAT Control Lighting Instructions Operating Instructions and Blower Operation Match Lighting InstructionsCleaning and Servicing Observed Problem Possible Cause Remedy TroubleshootingODS/pilot lights, but flame Illustrated Parts Breakdown DIS33N/P Replacement Parts ListIllustrated Parts Breakdown Replacement Parts are Available Through Your Retailer BOCL18 Blazing OAK Logs23D8036 Basic Warranty Five Year Warranty