GETTING STARTED
MAKE SURE YOU HAVE RECEIVED ALL PARTS
Check your packing list to verify that all listed parts have been received. You should have the following:
• Installation/Operating instructions | • | Black Louvers (5) |
| |
• 33" unvented gas heater with brick panels. | • | Canopy |
| |
• Volcanic rock and rock wool |
| • Two (2) anchoring screws | ||
• Mounting screws for canopy |
|
|
| |
• Log box (refer to installation instructions) |
|
|
| |
Accessory face plates available to finish the insert. |
|
|
| |
• DIFACESM | Black small face 33"H x 43"W | • | DIFACELG | Black large face 36"H x 50"W |
Accessories include brass trim and mounting hardware
The
• Hand held Remote with Receiver | • Wall switch with 15' wire. | • | Wall |
• Hand held Thermostat Remote with Receiver | • | Thermostat Sensor | |
WARNING
•Handle the gas log burner assembly by the grate only. Do not pick the unit up by the burners.
•Gloves are recommended when handling ceramic fiber logs to prevent skin irritation from loose fibers. Logs are fragile — handle with care.
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have all parts in good condition.
WHAT YOU WILL NEED FOR INSTALLATION
You must have the following items available before proceeding with installation…
• External regulator (for propane / L.P.G. and 1/2 lb. Natural Gas Systems only)
• Piping which complies with local codes | • | Sediment trap |
• Tee joint | • Pipe wrench or appropriate size crescent wrench set | |
• Phillips head screwdriver | • Drill with 5/32" bit | |
• Optional face plate kit. | • | Manual shutoff valve |
•Optional trim kit for installation into wall or free standing Mantle without three piece faceplate
•Pipe sealant approved for use with propane / LP.G (Resistant to sulfur compounds)
23D8036 | 7 |