INSTALLATION
SIDE PANEL INSTALLATION
One set of side panels needs to be installed on the stove. When installing stainless steel side panels - follow the handling and cleaning instructions below.
Before installation, panels must be handled and cleaned as per instructions noted below:
Stainless Steel Panels
•Stainless panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time. Claims for damage after installation will not receive consideration.
•To protect the finish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even when removing protective coating).
•Use a hair dryer to remove the protective coating from the panels.
•Stainless panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
*All hand and fi nger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/ residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat to the unit. Failure to do this will result in burn stains on panels which you will be unable to remove. Not protected by product warranty.
1)Bend the metal tab (located in the top front corner of the side panels to a 45° angle - with a pair of pliers.
45° bend
Note: Do not bend the tab back and forth - as this will weaken the metal.
2)Remove cast top - carefully place off to the side.
3)Position the left side panel - so the tab rests on the side panel bracket on the unit.
**Left panel can be identified by the 2 small holes near the bottom for the logo plate - see diagram 1.
Side panel
Bracket
4)Install Regency logo on to the left side panel - by snapping
logo into 2 holes located on the lower front corner of the panel.
Diagram 1
5)Ensure the back edge of the side panel is over the top of the two back shield tabs located at the back of the unit.
Left side
panel
Back Panel
ShieldTabs
6)Secure side panel to the two back shield tabs on unit with screws.
Side Panel | Top View | |
| Tab | |
|
| |
|
| 6) Repeat Steps |
|
|
|
16 |
|
|
| Regency CS1200 Freestanding Wood Stove | |
|
| |