MAINTENANCE
SAFETY GUIDELINES AND
WARNINGS
1)Never use gasoline, gasoline type lantern fuels, kerosene, charcoal lighter fuel, or similar liquids to start or ‘freshen up’ a fire in your heater. Keep all such liquids well away from the heater while it is in use.
2)Keep the door closed during operation and maintain all seals in good condition.
3)Do not burn any quantities of paper, garbage, and never burn flammable fluids such as gasoline, naptha or engine oil in your stove.
4)If you have smoke detectors, prevent smoke spillage as this may set off a false alarm.
5)Do not overfire heater. If the chimney connector, flue baffle or the stove top begin to glow, you are overfiring. Stop adding fuel and close the draft control. Overfiring can cause extensive damage to your stove including warpage and premature steel corrosion. Overfiring will void your warranty.
6)Do not permit creosote or soot
7)Your Regency stove can be very hot. You may be seriously burned if you touch the stove while it is operating, keep children, clothing and furniture away. Warn children of the burn hazard.
8)The stove consumes air while operating, provide adequate ventilation with an air duct or open a window while the stove is in use.
9)Do not connect this unit to a chimney flue serv ing another appliance.
10)Do not use grates or andirons or other methods for supporting fuel. Burn directly on the bricks.
11)Open the draft control fully for 10 to 15 seconds prior to slowly opening the door when refuelling the fire.
12)Do not connect your unit to any air distribution duct.
13)Your woodstove must burn dry, seasoned- standard firewood only. The use of cut lumber, plywood, “mill ends”, coal, charcoal etc. is prohibited as this fuel can easily overheat your woodstove. Evidence of excessive overheating will void your warranty. As well, a large portion of sawmill waste is chemically treated lumber, which is illegal to burn in many areas. Salt drift wood, chemically treated fire logs and wet/green wood also must not be burned in your woodstoves.
14)Do not store any fuel closer than 2 feet from your unit. Do not place wood, paper, furniture, drapes or other combustibles near the appli- ance.
15)WARNING: Do not operate without either the Ash Plug properly seated or the Ash Dump Plates screwed in place, excessive temperatures will result.
16)Do not operate unit with broken glass.
FAN MAINTENANCE
TO REMOVE THE FAN:
Reverse Steps 5-2 in fan installation section.
Maintenance: The sealed bearings are lubricat- ed, there is no need to lubricate them further. (Ex- tra lubricant will cause more lint and dust buildup
-causing the bearings to prematurely fail). Regular cleaning and vacuuming of the fan area will add to the life of the motor.
IMPORTANT:
These fans collect a lot of dust from within your home. Ensure you maintain these fan motors on a regular basis by vacuuming
the fan blades and housing using a soft brush nozzle.
24
Regency CS1200 Freestanding Wood Stove