Regency E21-LP1, E21-NG1 installation manual LOG SET Installation, Faceplate & Trim Installation

Page 12

INSTALLATION

LOG SET

INSTALLATION

Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.

The gas log kit (set# 532-930) contains the following:

a)02-66 Rear Log

b)02-67 Front Left Log

c)02-68 Middle Left Log

d)02-70 Middle Right Log

e)02-69 Front Right Log

f)Embers

g)Vermiculite

h)Rockwool

Note: Install Optional Brick Panels prior to installing logs.

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

A)02-66 D)02-70

C)02-68 B)02-67 E)02-69

The "02" refer numbers (i.e. 02-66) are molded into the rear of each log.

2)Sprinkle the vermiculite around the fi rebox base. Take some of the embers (approx. 1/3 of the bag) and sprinkle over the vermiculite.

NOTE: Keep the gasket on the front edge of the firebox clear of vermiculite.

4)Place the Front Left Log B) 02-67 on the 2 front pins.

5)Place the Middle Right Log D) 02-70 into the cutout on Rear Log A) 02-66 and the bottom front of Log D)02-70 snugly between Logs C) 02-68 and Log B)02-67.

6)Position the Middle Left Log C) 02-68 onto the 2 pins as shown below. The left edge of the log fi ts into a notch on the Front Left Log B) 02-67

Cutout fi ts over

E)02-69the right

edge of the burner

tray.

9)Place the Front Right Log E) 02-69 onto the front right pin and the cutout on the bottom right side of the log snugly against the right edge of the burner tray.

Vermiculite &

Vermiculite

Vermiculite

Embers

& Embers

& Embers

3)Place the

Rear Log A) 02 - 66 on the 2 pins on the r e a r l o g support and c a r e f u l l y p u s h down.

The front bottom of Log D)02-70 sits snugly between Logs C) 02-68 and Log B)02-67.

7)Place the embers on the front lip of the burner as shown below.

8)Place pieces of rockwool on the front lip of the burner as shown below.

FACEPLATE & TRIM

INSTALLATION

1)Lay the faceplate panels fl at, face down on something soft so they don't scratch.

2)Take the top faceplate and align the holes in it with the holes in the side panels. Using the screws provided, attach from the top of the panel (the holes in the top panel are slightly larger than the holes in the side panel to facilitate easier installation). See diagram 1. Hint: Don't tighten the trim to the bottom of the faceplate side panels with the screws provided. See diagram 1.

12

Regency E21 Gas Fireplace Insert

Image 12
Contents E21 Gas Insert 918-354a 10/25/05Congratulations You are the owner of a state-of-the-art Gas Insert byTable of Contents Safety Label Approved for bedroom installationsFor the State of Massachusetts, installation Installation Save These InstructionsBefore YOU Start Installation Checklist Minimum Fireplace ClearancesClearances to Combustibles If the framing is made of metal studs covered with a nonCombustible board GAS Connection High ElevationSystem Data Natural Gas Propane Burner #43 #54Wiring Diagram for the E21-NG1 and E21-LP1 GroundingLug Detail GAS Pipe Pressure Testing Offset Flue AdaptorVenting GAS Insert Aeration System Test for Flue SpillageOptional Brick Panel Valve DescriptionLOG SET Installation Faceplate & Trim InstallationPlace the Front Left Log B 02-67 on the 2 front pins A02-66 D02-70 C02-68 B02-67 E02-69Power cord should be run behind the faceplate panel SwitchFlush Glass Are different. See diagram below Flush LouversBAY Louvers Conversion Kit from Natural Gas to Propane Model #533-969 Installation Full Screen Front Close screen doors Thermostat Wire Table Connect the two wires to the gas valve. See diagram belowWire Size Wall ThermostatOperating Instructions For Your Safety Read Before Lighting Copy of Lighting Plate InstructionsMaintenance Door Glass Replacement Removing Valve AssemblyFlush Glass Replacement Removing the FANParts List DescriptionBurner Assembly & LOG SET Bay Door Flush DoorFaceplate Standard-Contour- Side Right Faceplate Standard-Contour-TopFaceplate Standard-Contour- Side Left Faceplate Standard-Contour- Trim RightRegency E21 Gas Fireplace Insert Regency E21 Gas Fireplace Insert Regency E21 Gas Fireplace Insert Warranty ConditionsInstaller Please complete the following information

E21-NG1, E21-LP1 specifications

The Regency E21-LP1 and E21-NG1 are premium gas fireplaces that embody the essence of modern heating technology while offering unparalleled aesthetic appeal. Designed to meet the demands of today’s homeowners, these models combine efficiency, style, and innovative features to elevate any living space.

One of the standout characteristics of the E21 series is its sleek design, which integrates seamlessly into a variety of home decors. Both the E21-LP1 and E21-NG1 are designed for liquid propane and natural gas respectively, ensuring versatility in fuel options. Their clean lines and minimalist profile make them an attractive focal point, perfect for modern, contemporary, or transitional interiors.

These gas fireplaces feature advanced heating technology, providing robust warmth quickly and efficiently. The E21 models are equipped with an impressive direct vent system that ensures optimal performance while maintaining indoor air quality. This means that the fireplace pulls air from the outside for combustion and vents exhaust back outside, allowing for ventilation without compromising on comfort.

Energy efficiency is a key characteristic of the Regency E21 models. They boast a high efficiency rating, which translates into lower heating costs and reduced environmental impact. The innovative burner design enhances flame presentation, providing a realistic and inviting fire that enhances the ambiance of any room.

Ease of use is also a significant benefit of the E21-LP1 and E21-NG1. With an intuitive control panel, users can easily manage the flame height and adjust the heat output to suit their needs. Many homeowners appreciate the convenience of remote control operation, allowing them to adjust their fireplace settings from the comfort of their seat.

Safety features are paramount in the design of the E21 models. Each fireplace is equipped with standard safety mechanisms, including an automatic shut-off system that activates in the event of a malfunction. This provides peace of mind for users, ensuring that their heating source is both effective and secure.

In summary, the Regency E21-LP1 and E21-NG1 offer a blend of modern design, advanced technology, and high efficiency, making them ideal choices for anyone looking to invest in a reliable and stylish gas fireplace. With an emphasis on user-friendly features and safety, they promise to deliver warmth and comfort for years to come.