Regency 510-994, 946-523/P specifications Mantel Leg Clearances with Contemporary Faceplate

Gas Fireplaces

					P33 Gas Fireplace
	Clearance Requirements with			Combustible Mantels with
	Contemporary Faceplate			Contemporary Faceplate
				Because of the extreme heat this fireplace emits, the mantel
				clearances are critical. Combustible mantel clearances from top of
				the louvers are shown in the diagram below. Mantel may be installed
				anywhere in the shaded area or higher.
		C
C
			B

Close to Ceiling

*Note: All measurements are from the top/side of the unit, not optional front.

Gas Fireplaces

Clearance:			Dimension	Measured
				From:
A: *Front Floor Clearance			1" (25mm)	Underside of
(min.)				Unit
B: *Sidewall		7-1/2" (241mm)		Side of Unit
C: *Ceiling
(room and/or alcove)			30" (889mm)	Top of Unit
D: Alcove Width		48" (1219mm)		Sidewall to
				Sidewall
				(Minimum)
				Front to
E: Alcove Depth			36" (914mm)	Back Wall
				(Maximum)
	Flue Clearances to
	Combustibles
	Horizontal - Top		2-1/2"
	Horiztonal - Side		1-1/2"
	Horiztonal - Bottom		1-1/2"
	Vertical (Flex Vent)		1-1/2"
	Vertical (Rigid)		1-1/4"

WARNING

Mantel Leg Clearances with

Contemporary Faceplate

Combustible mantel leg clearances from side of unit as per diagram below:

Clearances are from the finished edge of the unit or an installed front.

Top View	3
	0-

Failure to maintain required clearances is a major cause of chimney related fires. Installation of this fireplace must comply with these clearances

Please note: Due to ongoing product development, product appearance and specifications are subject to change without notice.

Caution Requirements

The top, back and sides of the fireplace are defined by standoffs. The metal ends of the standoff may NOT be

recessed into combustible construction.

WARNING

Fire hazard is an extreme risk

if these clearances (air space) to combustible materials are not adhered to. It is of greatest importance that this fireplace and vent system be installed only in accordance with these instructions.

August 2008 Product Specifications Book 31