LPG Conversion Kit Contains Qty Description

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!

Each Kit contains one LPG Conversion Kit and one DC Sparker Kit.

LPG Conversion Kit Contains:

1918-590 Label "Converted to LPG"

1904-531 Bushing Split Plastic

0.500 in.

6) Remove the Grate by removing the 2	10) Remove burner oriﬁ ce with 1/2"
screws; one on each side of the grate.	wrench. Use another wrench to hold
	onto the elbow behind the ofﬁ ce
	Replace with the #54 oriﬁ ce in the Kit.

	Remove the 2 screws holding	Burner
	Remove the 2 screws holding	Oriﬁ ce
	the grate in position.	Oriﬁ ce
	the grate in position.
	7) Remove the Burner Tray by removing 1	11) Turn control knob to the “OFF”
	screw on each side of the tray, then slide	position.
	the tray to the left and lift out.
		12) Remove the black protection cap by
		hand from the high-low knob (Fig.1).

1904-543 Screw 8-32 x 3/4 Pan Head

2904-553 Screw #8 x 1/2 Type "B",

Black Oxide

1910-073 Spark Generator Battery Holder

1910-903 Wire Fan To Power Cord Ground 30 in.

904-781 Velcro Hook, Black

904-782 Velcro Hook, Black

1)Turn the unit off and allow it to cool to room temperature.

2)Shut off gas supply.

3)Unplug or disconnect power source to stove.

4)Remove glass front (see Door Glass Replacement section in the manual).

5)Remove logs and brick panels (if installed).

Remove the 2 screws,

push Burner Tray to the left, and lift off.

8)Pull off the pilot cap to expose the pilot oriﬁ ce.

9)Unscrew the pilot oriﬁ ce with the allen key (provided) and replace with the LP pilot oriﬁ ce in the kit.

Fig. 1

13)Insert a 5/32” or 4mm Allen wrench into the hexagonal key-way of the screw (Fig. 2), rotate it counter-clockwise until it is free and extract it.

Fig.2

Regency® E21-3 Gas Fireplace Insert