MAINTENANCE
DOOR GLASS
REPLACEMENT
Your Regency® stove is supplied with high temperature, 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In the event that you break your glass by impact, purchase your replacement from an authorized Regency® dealer only, and follow our
Bay Glass Removal
1)Remove the door from the unit and place on a soft surface to prevent scratching.
2)Remove the nuts holding the glass retainers in place.
3)Remove the glass retainers (sides, top and bottom).
4)Replace the glass. The glass must have gasketing around it.
5)Reverse the previous steps, replace the retainers and fasten with the nuts but do not over tighten, as this can break the glass.
6)Replace door on the stove and check the seal.
REMOVING VALVE
ASSEMBLY
1)Disconnect the power.
2)Shut off the gas.
3)Remove top and bottom louvers.
4)Remove top and bottom trim.
5)Remove glass.
6)Remove log set & embers, and brick panels.
7)Disconnect the gas line.
8)Remove wires from valve (top and bottom terminals).
9)Remove the burner tray by removing the 1 screw on each side, then slide the tray to the left and lift out.
12)Remove the 2 screws on each side of the firebox bottom and 4 screws on the rear wall., and lift out.
13)Remove valve assembly from stove body by removing 3 phillips screws.
14)Remove the valve from the bracket and replace. Reverse steps to install valve.
Flush Glass Replacement
Replace with new flush front per instructions in the "Flush Glass" section.
Remove 2 screws, then push burner tray to
left and lift out.
10)Remove the 2 screws to the right of the cutout on the firebox bottom.
11)Remove the switch cover from the left side of the body base and pull the thermodisc out of the bracket under the left side of the firebox bottom.
REMOVING THE FAN
IMPORTANT
Disconnect power supply
before servicing.
1)Disconnect the power.
2)Shut off the gas.
3)Remove top and bottom louvers.
4)Remove top and bottom trim.
5)Remove glass.
6)Remove logs, embers, and brick panels.
7)Remove Burner Tray and Firebox bottom - see steps 9) to 12) in "Removing Valve Assembly.
8)Remove wires from fan.
9)Lift fan off of the two pins.
10)Reverse steps to install fan.
Remove the 2 nuts holding the switch box in place, then pull the thermosdisc out of the bracket.
30 | Regency® |