Nilfisk-ALTO 46/53 Service Chart, Hour Weekly Maintenance Checklist, Hour Maintenance Checklist

Page 34

SERVICE CHART

SERVICE CHART

Check items for proper operation. If service is required, please contact an authorized American-Lincoln dealer. For best performance, replace worn parts with genuine American-Lincoln parts.

EVERY 8 HOURS or DAILY operation check and clean/adjust if necessary:

1.Inspect panel filters for damage and clean them.

2.Check hydraulic fluid level.

3.Check all flaps for wear or damage.

4.Check brooms for wear or damage, adjust as required.

5.Check panel filters (clean side) for leakage.

6.Check brake pedal and parking brake.

7.Check hydraulic oil filter.

8.Check battery electrolyte level (unless maintenance-free battery).

9.Check all fluid system components for leaks.

50 HOUR (WEEKLY) MAINTENANCE CHECKLIST

10.Check solution tank (recycling or ESP system).

11.Check solution filter screen (recycling or ESP system).

12.Check recovery tank.

13.Check recovery tank screens and filters.

14.Inspect scrub brushes for wear or damage.

15.Inspect rear and side squeegees for wear or damage.

16.Check battery electrolyte level (unless maintenance-free battery).

17.Check all hydraulic hoses for wear or cuts.

18.Rotate main brush (end-over-end).

19.Clean or replace panel filters.

20.Lubricate dump system and drive wheel pivot points.

100 HOUR MAINTENANCE CHECKLIST

21.Lubricate drive wheel, swivel wheel bearings, and steering rack guide.

22.Lubricate front wheel bearings.

23.Lubricate all moving joints.

24.Check brake shoes for wear and adjust accordingly.

25.Lubricate all 3 DANHOUSER bushings with NAPA #765-1363 or equivalent anti-seize lubricant. The bushings are located on the steering, scrub deck lift, squeegee lift, variable dump hopper door.

250 HOUR MAINTENANCE CHECKLIST

26.Lubricate squeegee casters.

27.Clean solution tank and filter screen.

28.Replace hydraulic filter element.

400 HOUR MAINTENANCE CHECKLIST

29.Clean hydraulic reservoir.

30.Clean hydraulic intake strainer.

31.Change hydraulic fluid.

500 HOUR MAINTENANCE CHECKLIST

32.Inspect brushes on pump and drive motors for wear. Replace as needed.

33.Inspect drive system cables for wear.

1-34

American-Lincoln

 

ATS 46-53 Battery

Image 34
Contents American-Lincoln Technology Table of Contents American-Lincoln ATS 46/53 Battery Options Specifications Tanks WarrantySqueegee HopperMachine Dimensions Standard Hardware & Torque Values SAE GradeHydraulic Torque Requirements Hydraulic Torque RequirementsDECIMAL-METRIC Conversion Table DECIMAL-METRIC Conversion TableMachine Preparation Preparing the Machine for OperationSafety Instructions Read the Instruction BookSafety Instructions Safety Instructions Operation of Controls and Gauges Light Switch See FigureHorn Button See Figure Combination Battery Condition & Hour Meter KEY Switch See FigureFORWARD/REVERSE Switch See Figure Seat Position Adjustment See FigureFilter Shaker Switch To Engage the Safety ARMSide Broom Lever Side Broom Adjustment See figureMain Broom Adjustment See Figure Side Broom Lever See FigureScrub Deck Switch See Figure Dust Control Switch See FigureSqueegee Switch See Figure Recycling or ESP & Autofil System Solution Control See FigureNON-RECYCLING or Standard Scrubbing System To Disconnect Water HoseRecovery High Light Hopper Temperature Light OptionSolution LOW Light Charging System LightBrake Pedal Foot Pedal AcceleratorParking Brake Hopper Lift Lever See Figure Hopper Dump Door Lever See FigureC1702batt Turn Signal 4-Way Option See Figure BACK-UP Alarm Switch Option See FigureFilter Panel Latch See Figure C1719C1718 Front Cover Latch See FigureHydraulic Reservoir Level Sight Gauge Hydraulic ReservoirLevel Sight Gauge Main Broom Compartment Doors See FigureHopper Door Lever See Figure Hopper Filter Cover See FigureRecycling System Detergent LOW ON/OFF Switch ESP System Operating InstructionsScrubbing System HOW IT Works Solution Tank Detergent Tank RecoveryNON-RECYCLING or Standard Scrubbing System HOW IT Works Check Recovery or ESP and Autofil System HOW IT WorksOrifice Floor ContactOperating Instructions Storage for BATTERY-POWERED Machines POST-OPERATION ChecklistBattery Charging Instructions Emptying the Debris HopperHelpful Hints for Cleaning Operation Main AisleHour Weekly Maintenance Checklist Service ChartService Chart Hour Maintenance ChecklistFront Service Precautions Service PrecautionsService Instructions Side Broom Service Replacing the Side BroomCleaning the Dust Control Filter Hopper ServiceCleaning the Hopper Checking the Hopper SealsReplacing the Dust Control Filter Dust FlapsAdjusting the Brakes Brake ServiceAdjusting the Brake Pedal BrakesFill Hydraulic Reservoir General Machine MaintenanceCleaning the Hydraulic System Filling the Hydraulic ReservoirBrush Latch Solution LOW Warning LightRecovery High Warning Light Replacing the Scrub BrushRecycling Pump Storage Adjusting CastersRecycling Pump ESP System Rear SqueegeeBattery Parts List Legend Abbreviations ScrewsProblem Probable Cause Remedy General TroubleshootingCheck & repair. orSereplaceahC -.Lynn Ordering Parts Internet Alto Headquarters

46/53 specifications

The Nilfisk-ALTO 46/53 is a powerful and versatile range of professional vacuum cleaners designed to meet the demanding needs of various cleaning applications. Known for their efficiency and reliability, these models are ideal for both commercial and industrial environments. With a robust construction, the Nilfisk-ALTO 46/53 series is built to withstand the wear and tear of daily use.

One of the standout features of the Nilfisk-ALTO 46/53 is its impressive suction power. Equipped with high-efficiency motors, these vacuum cleaners ensure optimal performance while consuming less energy. This not only enhances productivity but also contributes to cost savings and environmental sustainability.

The design of the Nilfisk-ALTO 46/53 is user-friendly, featuring an ergonomic handle and lightweight construction that make it easy to maneuver in tight spaces. Its compact design does not compromise on the capacity, as the model comes with a generous tank size, allowing for extended cleaning sessions without frequent interruptions for disposal.

Another notable characteristic of the Nilfisk-ALTO 46/53 is its advanced filtration system. The vacuum includes a HEPA filter, which captures fine dust and allergens, ensuring a cleaner and healthier environment. This feature is particularly beneficial in settings where air quality is critical, such as hospitals and laboratories.

In terms of versatility, the Nilfisk-ALTO 46/53 is equipped with various accessories and attachments designed to tackle different surfaces and cleaning tasks. From upholstery to hard floors, the adjustable settings and specialized tools ensure that users can achieve optimal results no matter the job at hand.

The Nilfisk-ALTO 46/53 also boasts noise reduction technology, making it suitable for use in noise-sensitive environments. Its low operational noise allows cleaning to occur without disturbing customers or staff, which is a major advantage for businesses operating during hours of high foot traffic.

In summary, the Nilfisk-ALTO 46/53 range combines powerful suction, advanced filtration, and user-friendly features into a single cleaning solution. Whether for commercial, industrial, or professional use, this vacuum cleaner stands out as a reliable option that meets a wide variety of cleaning needs while promoting efficiency and health.